Filter
Top Products
38
GB
6 Press AMS or YES.
“(S.F) Edit OK?” appears in the display.
7 Press AMS or YES again.
The deck starts recording over the existing
track. “S.F Edit(:) ** %” appears while the
track is being recorded. An amount of time
that is roughly equal to or longer than the
playback time of the track is required when
recording over the track. When the recording
finishes, “Complete!” appears.
Fade-in and Fade-out
Recording
1 While the deck is stopped, playing, or
paused, press MENU/NO.
“Edit Menu” appears in the display.
2 Turn AMS (or press ./>
repeatedly) until “S.F Edit?” appears,
then press AMS or YES.
3 Turn AMS (or press ./>
repeatedly) until “Fade In?” or “Fade
Out?” appears, then press AMS or YES.
4 Turn AMS (or press ./>
repeatedly) until the track number you
want to change the recording level
appears, then press AMS or YES.
“Time **s” appears in the display.
5 While monitoring the sound, turn AMS
(or press ./> repeatedly) to
change the Fade-in or Fade-out
Recording time.
The deck plays the portion that will be
recorded over using Fade-in or Fade-out
Recording.
You can set the time at any value between
1 second and 15 seconds, in 0.1 second
increments. You cannot set the time longer
than the track.
6 Press AMS or YES.
“(S.F) Edit OK?” appears in the display.
7 Press AMS or YES again.
The deck starts recording over the existing
track. “S.F Edit(:) ** %” appears while the
track is being recorded. When the recording
finishes, “Complete!” appears.
To cancel the operation
Press MENU/NO or x in steps 1 to 6. If you
press AMS or YES in step 7 and recording
starts, you cannot interrupt the operation.
Notes
• Do not disconnect the mains lead or move the
deck while recording is in progress. This may
damage the recording data preventing recording
from being performed properly.
• You cannot change the recorded level of a track
recorded in LP2 or LP4 Stereo mode.
• Do not use an MD that is damaged or dirty. This
may prevent recording data from being recorded
properly.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• You cannot undo any S.F edit operation with the
Undo Function.