Filter
Top Products
35
US
Getting Started
1 Press RECEIVER.
The RECEIVER indicator lights up and
receiver operation is activated.
2 Press MENU.
“1-LEVEL” appears on the display.
3 Press or b to enter the
menu.
4 Press V/v repeatedly to select
“T. TONE”.
5 Press or b to enter the
parameter.
6 Press V/v repeatedly to select
“T. TONE Y”.
The test tone is output from each speaker
in sequence as follows:
Front left t Center t Front right t
Surround right t Surround left t Sub
woofer
7 Adjust the speaker levels and
balance using the LEVEL menu
so that the level of the test tone
sounds the same from each
speaker.
For details, see “Adjusting the level
(LEVEL menu)” (page 43).
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–. You can also
use MASTER VOLUME on the receiver.
• The adjusted value are shown on the display
during adjustment.
8 Repeat steps 1 to 6 to select
“T. TONE N”.
You can also press any input buttons.
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely.
• The speaker cords may have the short-circuit
problem.