Filter
Top Products
ENGLISH
01/4/26 99secl_E_3.fm
E-12
Basic Operation
-Recording-
„
To prevent recorded MiniDiscs from being
erased accidentally
Slide the accidental erase prevention tab, located on the
side of the MiniDisc, in the direction indicated by the
arrow.
The MiniDisc will then be protected against accidental
erasure.
To add a recording to such a MiniDisc, slide the acciden-
tal erase prevention tab back to its original position.
„
Helpful tip when attaching a label
When attaching a label to an MiniDisc cartridge, be sure
to note the following. If the label is not attached properly,
the MiniDisc may jam inside the unit and it may not be
possible to remove it.
„
About sampling rate converter
This portable MD incorporates a sampling rate converter
meaning it can record from digital radios or DAT tape
recorders.
„
Note for digital recording
You cannot copy a MiniDisc that you recorded from digital
inputs to another MiniDisc or DAT. It is prevented by the
SCMS (Serial Copy Management System). Recording
from analogue inputs is not affected.
z
If the label peels off or partially lifts
away, replace it with a new one.
z
Do not put a new label on top of an ex-
isting one.
z
Attach the label only in the specified
location.
Digital signals Digitally recorded
MiniDisc
Cannot record
MD-MT99C