Filter
Top Products
E-19
Maintenance
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth.
Caution:
Do not use chemicals for cleaning (petrol, paint
thinner, etc.). It may damage the cabinet fi nish.
Do not apply oil to the inside of each component. It
may cause malfunctions.
Error indicators and warnings
When you fail to perform operations properly, the
following messages are displayed on the sound bar.
Display Meaning
(Display blinks)
When there is no input signal.
Play back the connected
equipment.
Nonstandard signal. Cannot
be recognized.
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
Poor connection of the digital
audio input terminal.
Turn off the sound bar
and check if the cable is
connected properly.
Error indicator
(blinks red)
When the protection circuit is
activated.
(*): Should the same message appear even if the
speaker is unplugged and plugged in, or is set to
the standby mode and on again, contact your local
dealer where you purchased the sound bar.
Specifi cations
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specifi cation
changes for product improvement without prior notice.
The performance specifi cation fi gures indicated are
nominal values of production unit. There maybe some
deviations from these values in individual unit.
Sound Bar
Power source
AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 38 W
Power standby: 0.4 W (*1)
Power standby: < 6 W (*2)
Dimension
Width: 1386 mm
Height: 74 mm
Depth: 68 mm
Weight
3.7 kg
Output power MPO:
160W (80W + 80W) (10% T.H.D.)
RMS: Total 160 watts
RMS:
160 W (80 W + 80 W) (10% T.H.D.)
RMS:
120 W (60 W + 60 W) (1% T.H.D.)
Output
terminal
HDMI™ output: (audio/video support
up to 1080p) x 1
Input terminal
500 mV / 47 kohms
Optical digital input (OPTICAL):
Square type x 1
HDMI input: (audio/video support up
to 1080p) x 2
Type
2 Way speaker system
5.7 cm woofer
2.5 cm Soft Dome
Bluetooth
Frequency
band
2.400GHz - 2.480GHz
Compatible
Bluetooth
Profi le
A2DP (Advanced Audio Distribution
Profi le), AVRCP (Audio/Video
Remote Control Profi le)
Bluetooth 2.1 +EDR
Maximum
input power
160 W
Rated input
power
80 W
Impedance
4 ohms
(*1): This power consumption value is obtained when
the sound bar is in low power consumption mode.
(*2): This power consumption value is obtained in the
STANDBY mode.
Subwoofer
Power source
AC 220 - 240 V ~ 50/60 Hz
Power
consumption
Power on: 33 W
Power standby: 0.4 W (*1)
Power standby: 0.4 W (*2)
Output power
MPO: 150W (10% T.H.D.)
RMS: 150 W (10% T.H.D.)
RMS: 120 W (1% T.H.D.)
Type
Subwoofer system
16 cm woofer
Maximum
input power
300 W
Rated input
power
150 W
Impedance
3 ohms
Dimensions
Width: 144 mm
Height: 432 mm
Depth: 306 mm
Weight
6.1 kg