Sennheiser SET50TV Headphones User Manual


 
Sennheiser electronic GmbH & Co. KG Phone +49 (5130) 600 0 Printed in China
30900 Wedemark, Germany Fax +49 (5130) 600 300 Publ.
10/06
www.sennheiser.com 517641 / A0
2
A
B
C
ƹ
¸
Ƹ
¹
»
³
·
²
¿
´
ƺ
Connecting the system components
̈
Plug in one end of the connecting cable
¸
to the socket on your sound source (e.g. television).
If necessary, use one of the adapters ¹
,
Ƹ
or
ƹ (not included)
.
Plug in the other end of the connecting cable
¸
to the blue socket
on the transmitter.
̈ Connect the mains unit ƺ to the transmitter ´ and to the mains.
̈ Place the receiver into the transmitter’s charging compartment ².
̈ Before you use the rechargeable battery for the first time, charge it for at least 14 hours.
̈ Adjust the volume of your sound source to a sufficient (medium) level.
Switching on and using the stethoset receiver
̈ Turn the volume control ³ in the direction of “ON” until it clicks.
̈ First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
̈ Use the balance control » to adjust the volume between the left and right ear.
̈ If you cannot hear anything through the receiver, increase the volume of your sound source.
Switching off the stethoset receiver
̈ To switch the receiver off, turn the volume control ³ in the direction of “OFF” until it clicks.
Charging the stethoset reciever
̈ Switch the receiver off. Place the receiver into the transmitter’s charging compartment ² without
exerting too much pressure. With a fully charged battery, the operating time is approx. 9 hours.
For details on the use of the Set 50 TV/Set 55 TV, please refer to the enclosed operating instructions.
Set 55 TV
Set 50 TV
Quick instructions