Filter
Top Products
To Adjust the Volume
Adjust the VOLUME levels to obtain the desired volume.
For Personal Listening
Connect headphones (Ø3.5mm stereo mini plug) to the earphone
jack. Adjust the VOLUME levels to obtain the desired volume.
When headphones are connected, the speakers are automatically muted.
Warning: Excessive sound pressure from earphone and headphones can cause hearing
loss.
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power plug from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightening storms or when unused for a long period of
time.
14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as the power-supply cord or plug is damaged, liquid has
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate normally,
or has been dropped.
SAFETY PRECAUTIONS
SAFETY PRECAUTIONS SYSTEM CONNECTIONS
IMPORTANT SAFETY INSTRUCTIONS
USER MANUAL
It’s important to read this instruction prior to using your new product for the
first time.
MOISTURE.
APPARATUS.
FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
connected.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
For Customers in Canada
regulations.
Warnings:
intended used. In order to disconnect the apparatus from the mains completely, the AC power
plug should be disconnected from the mains socket outlet completely.
newspaper, table-cloths, curtains, etc.
.
On Safety
As the laser beam used in this compact disc player could be harmful to the eyes, do not attempt
to disassemble the casing. Refer servicing to qualified personnel only.
may be defeated allowing the laser to remain on when the lid is opened.
checked by qualified personnel before any further operation.
On Operation
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded
with high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of
the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged
when the peak level of the sound is played. The lens of the laser should be kept clean. Do not touch
the lens. If you do so, the lens may be damaged and the unit will not operate correctly.
On Use
- Heat sources such as radiators or air ducts.
- Direct sunlight.
- Excessive dust.
- Moisture or rain.
- Mechanical vibration or shock.
- Uneven surface.
If you do so, the temperature inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit.
the moisture may condense on the lens inside the unit. Should this occur, the unit will not
operate. In this case, remove the disc and leave the unit in a warm place for several hours
until the moisture evaporates.
Additional safety information
such as vases, shall be placed on the apparatus.
serviceable components.
Precautions
corresponds to the cartridge and stylus of a record player. Although this product incorporates
a laser pick-up lens, it is completely safe when operated according to directions.
from collecting on the pick-up lens, do not leave the compartment door open for an extended
period of time. If the lens becomes dirty, clean it with a soft brush, or use an air blower brush
designed for camera lenses.
Headset safety
unit before you put on headphones. Increase the volume to the desired level only after
headphone are in place.
volume play.
situations. Even if your headset is an open-air designed to let you to hear outside sounds, do
not turn up the volume so high that you are unable to hear what is around you.
Portable Cart Warning
Using FM and AM Antennas
need to connect the AM loop antenna to the back of the unit if you listen to AM stations.
Rotate the AM loop antenna for better reception.
Speaker Connections
Connect the right speaker to the R (R+ & R-) terminals and the left speaker to the L (L+ & L-)
terminals.
Note:
Connecting speakers other than the speakers supplied with the unit may damage
the unit.
CAUTIONS:
identification sticker located on the back of your unit. (AC 120V ~ 60Hz)
the wall outlet.
not disconnect it from the mains supply. To completely isolate the equipment, remove
the plug from the mains jack as some components remain connected to the electrical
supply.
REMOTE CONTROL
1. PRESET EQ Button
2.
ON / STANDBY Button
3. SLEEP Button
4. PROG / MEM /
Button (same as
PROG / MEM /
button on the unit)
5. RANDOM Button
6. MEM.UP /
Button
7.
STOP / BAND Button
8. FUNCTION Button
9. TIMER Button
10. DISPLAY Button
11.
/ Buttons
12. VOLUME + / - Buttons
13.
PLAY / PAUSE Button
Using the Remote Control Correctly
To Change Battery
ATTENTION
Remove the plastic sheet
before operating the remote
control.
1. Open the battery door.
2. Insert one CR2025 (3V) size battery.
Battery Replacement
When the battery becomes weak, the operating distance of the remote control is greatly
reduced and you will need to replace it.
Note: If the remote control is not going to be used for a long time, remove the battery to
avoid damage caused by battery leakage corrosion.
WARNINGS:
equivalent type.
CAUTION: When discarding batteries, environmental problems must be considered and
local rules or laws governing the disposal of these batteries must be strictly followed.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
21
20
22
23
1. Press the STANDBY/ON button to turn the unit on.
2. Press the FUNCTION button to TUNER mode.
3. Press the
STOP/BAND button to select a band (FM/AM).
4. Press the
or button to tune in to a station.
5. Adjust the volume levels.
Searching for a Station Automatically
or button until the tuner starts searching for a station, then
release. After tuning in a station, the search stops.
- 1 - - 2 - - 3 - - 4 -
to alert the user to the presence of uninsulated “dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to cause an electric shock.
The exclamation point within the equilateral triangle is intended to alert the user to
the presence of important operating and maintenance (servicing) instructions in this
user manual.
This product contains a low
power laser device.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
PRODUTO LASER CLASSE 1
DEFEATED
Double insulation when servicing use only
identical replacement parts.
L
SPEAKER
LEFT
SPEAKER
To AC
outlet
AM loop
antenna
LOCATION OF CONTROLS
Front View Rear View
1. CD Door
2.
PLAY/PAUSE Button
3. TUNING + /
Button
4. TUNING - /
Button
5. LCD Display
6. FUNCTION Button
7.
STANDBY/ON Button
8. PRESET EQ Button
9. VOLUME (- / +) Knob
10.
Earphone Jack
11. iPod Docking
12.
STOP / BAND Button
13.
OPEN / CLOSE Button
14. Standby Indicator
15. TIMER Indicator
16. Remote Sensor
17. PROG / MEM /
Button
18. MEM.UP /
Button
19. AUX IN Jack
20. AM Antenna Terminal
21. FM Antenna
22. Right & Left Speaker Terminals
23. AC Power Cord
VOLUME ADJUSTMENT
CLOCK SETTING
mode, the standby indicator illuminates.
1. Press and hold the PROG/MEM/
button until the hour digits
blink.
2. Tap the
or button to adjust the desired hours then tap the
PROG/MEM/
button once to confirm. The minute digits will begin
to blink.
3. Tap the
or button to adjust the desired minutes then tap the
PROG/MEM/
button once to start clock.
Notes:
DISPLAY button once to display the current time.
DISPLAY button once to display the current time.
AM
AM
AM
AM
LISTENING TO THE RADIO
Red(+) and Black(-)
Red(+) and Black(-)
RS2696i
1
2
3
4
5
6
7
8
9
10
11
12
13