Filter
Top Products
Your receiver works with the transmitter of your
2.4 GHz USB Connection Digital Audio Link.
Refer to the user’s guide of your 2.4 GHz USB
Connection Digital Audio Link before using your
receiver.
• To avoid injury, do not connect the provided
power adapter to a ceiling outlet.
• Use only an adapter that supplies 9V DC and
delivers at least 200mA. Its center tip must be
set to positive.
• Unplug the AC adapter from the AC outlet
before unplugging from the receiver.
• For better performance and greater reception
range, keep the receiver and transmitter away
from wireless LAN access points, microwave
ovens, and wireless networks or phones that
run on 2.4 GHz frequency.
15-124
2.4 GHz Digital Audio Receiver
Thank you for purchasing your 2.4 GHz Digital
Audio Receiver from RadioShack. This add-on
receiver is designed for use with your 2.4 GHz USB
Connection Digital Audio Link.
Power indicator
Lights when your
transmitter (not supplied)
and receiver link.
Receiver
AC Adapter
3.5mm Stereo Y-Type Patch Cable
3.5mm Stereo Audio Cable
User’s Guide
Frequency Range ...................................................2.4 ~ 2.4835 GHz
Channel Frequency .....................................2410, 2419 ~ 2473 MHz
Channel Spacing ......................................................................9 MHz
Frequency Stability ...............................................................±1 MHz
Transmission Range ........................45 ft (15 m, in the home) (Max.)
....................................................
100 ft (30.5 m, line of sight) (Max.)
Operating Temperature ...........................32°F to 104°F (0°C to 40°C)
Power Supply ......................................120VAC/60Hz, 9V DC/200mA
Response ................................................................20 ~ 20kHz±3dB
S/N Ratio ...........................................................................40dB (Min.)
Sensitivity .................................................................−85 dBm (Min.)
Output Impedance ........................................... >10K Ohm (3.5 mm)
Output Level ...................................................................2 Vms±10%
Dimensions (H x W x D) .......................................3.4 x 3.4 x 1.3 Inch
...............................................................................
(86 x 86 x 32 mm)
Weight ............................................................................2.29 oz (65 g)
Specications are subject to change and improvement without
notice. Actual product may vary from the images found in this
document.
Notes
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult your local RadioShack store or an experienced
radio/TV technician for help. If you cannot eliminate the
interference, the FCC requires that you stop using your
receiver. Changes or modications not expressly approved
by RadioShack may cause interference and void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Product
2.4 GHz
Digital Audio Receiver
Model 15-124
Responsible
Party
RadioShack
300 RadioShack Circle
Fort Worth,TX 76102
Phone 817-415-3200
This product is warranted by RadioShack against manufacturing defects
in material and workmanship under normal use for ninety (90) days from the
date of purchase from RadioShack company-owned stores and authorized
RadioShack franchisees and dealers. For complete warranty details and
exclusions, check with your local RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102 04/04
Please read this user’s guide before
installing, setting up, and using your new receiver.
www.radioshack.com
©2007. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
15-124
02A07
Printed in China
what’s included
specications
rf emissions information
limited 90-day warranty
using your receiver
Connect the 3.5mm stereo
Y-type cable or 3.5mm stereo
audio cable, then connect the
other end to your stereo’s
audio input jacks.
Connect the 9V AC
adapter, then plug
the other end into a
standard AC outlet.