Pioneer XV-GX3 Home Theater System User Manual


 
Before you start
01
5
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 1
Before you start
Checking what’s in the box
Please check that you've received the following
supplied accessories:
Remote control
Dry cell batteries (AA/R6) x2
Video cord
AM loop antenna
FM antenna
Power cord:
Singapore, Malaysia, Taiwan, Indonesia
and Philippines models x2
All other models x1
Non-skid pads (in speaker box) x8
These operating instructions
Loading the batteries
Use AA/R6 batteries with the supplied remote
control. Make sure to follow the indications (
,
) inside the compartment.
Important
Incorrect use of batteries may result in such
hazards as leakage and bursting. Observe the
following precautions:
Never use new and old batteries together.
Insert the plus and minus sides of the
batteries properly according to the marks
in the battery case.
Batteries with the same shape may have
different voltages. Do not use different
batteries together.
When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction’s rules
that apply in your country or area.
Attaching the non-skid pads
Use the self-adhesive non-skid pads to provide
a stable base for the speakers. Attach four to
each speaker as shown below.
Removing the front speaker grilles
If necessary, remove the front speaker grilles
as described below.
1 Gently ease the grille loose by gripping
the bottom and pulling towards you.
2 Pull the top free in the same way.
When reattaching, start from the top then push
the bottom in until secure.
It is not recommended (due to dirt and
dust) to leave the speaker grilles removed.
If the speaker grille is not properly attached
to the front of the speaker, it is possible it
may fall off and cause injury. Therefore, we
don’t recommend placing the speaker in
high locations where this is likely to
happen.
XV-GX3.book 5 ページ 2005年7月6日 水曜日 午前11時42分