Filter
Top Products
VOLTAGE SELECTOR SWITCH
Only multi-voltage model is provided with
this switch.
Always check that selector are set properly
before plugging the power cord into the wall
outlet.
1. Disconnect the power cord.
2. Use a small-sized screwdriver.
3. Insert the screwdriver into the groove on
the voltage selector, and adjust the
VOLTAGE SELECTOR.
240 V
VOLTAGE SELECTOR
220V
–230V
110V
–120V
CAUTION 240 V
Power source voltage is factory adjusted at
240 volts. If your area is different, change
the voltage selector’s setting.
H039En
On the inside cover of the unit.
Wall-mounting the center and
surround speaker system
Before mounting
• Remember that the speaker system is heavy
and that its weight could cause the wood
screws to work loose, or the wall material to
fail to support it, resulting in the speaker
falling. Make sure that the wall you intend to
mount the speakers on is strong enough to
support them. Do not mount on plywood or
soft surface walls.
• Mounting screws are not supplied. Use
screws that are suitable for the wall material
and that will support the weight of the
speaker.
• If you are unsure of the qualities and
strength of the walls, consult a professional
for advice.
• Pioneer is not responsible for any accidents
or damage that result from improper
installation.
Wood screw
Protrusion: 5-7mm
5 mm
5 mm
10 mm
NS03_ZFL.book 3 ページ ２００３年７月３１日 木曜日 午後７時０分