Pioneer XV-DV282AP Home Theater System User Manual


 
Getting started 04
17
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Chapter 4
Getting started
Setting Speaker Layout
Select the speaker layout for the speaker
setting you arranged to your listening area
environment.
First time you switch on the system, the
following speaker layout setting appears. If you
switch off the system without finishing this
setting, the same appears again next time you
switch on the system.
1 Press
STANDBY/ON
and confirm
WELCOME is shown on the display.
2 SELECT SPEAKER LAYOUT will run on
the display for about 10 seconds.
3Use / to select appropriate speaker
layout.
There are two speaker layout modes – 5 spot
speaker layout and 3 spot speaker layout.
See Setup Guide for more details about
speaker layout and mode description.
5 SPOT – Optimal for 5.1 channel home
theater sound by placing the two surround
speakers in the rear of the listening
position.
4 SPOT (HTZ181DVD only) – This is the
standard layout for listening to the
surround sound, which is similar to the 5
spot speaker layout. The two center
speakers are separated to the right and left
sides, and neatly arranged around the TV.
3 SPOT – This is the classic layout for the
Front Surround mode. The two surround
speakers are placed in front of the listening
position.
2 SPOT (HTZ181DVD only) – This layout
for the Front Surround mode is the same
as the 3 spot speaker layout. The two
center speakers are separated to the right
and left sides, and neatly arranged around
the TV.
4 Press ENTER to confirm.
1
Setting the channel levels
Set the relative channel levels from your main
listening position.
2
1Press
SHIFT+SETUP
.
2Use / to select SOUNDSET, then
press ENTER.
3Use / to select CH LEVEL, then
press ENTER.
4Use / to select TESTTONE, then
press ENTER.
The test tone is output in the following order
(from the speakers active in the current
listening mode):
L – Front left speaker
C – Center speaker
R – Front right speaker
SR – Surround right speaker
SL – Surround left speaker
SW – Subwoofer
3
Note
1 To change the setting, press SHIFT+SETUP, use / to select SYS SET, then use / to select LAYOUT to start setting
procedure.
2 • This is only available when DVD/CD is selected and playback is stopped. Also make sure headphones are unplugged.
• To adjust the overall balance while listening to any sound source you want, press SHIFT+SETUP, use / to select
SOUNDSET, then press ENTER. Use / to select CH LEVEL, then press ENTER. Use / to switch between channels, and
/ to adjust the channel levels. Press ENTER when you’re finished.
3 Since the subwoofer produces ultra-low frequencies its sound may seem quieter than it actually is.
HTZ180_181_280_282DVD_En.book 17 ページ 2009年3月13日 金曜日 午後2時50分