Pioneer VSX-9110TXV-K Home Theater System User Manual


 
Using other functions
10
63
En
Press
RECEIVER
then press
SLEEP
repeatedly to set
the sleep time.
You can check the remaining sleep time at any time
by pressing
SLEEP
once. Pressing repeatedly will
cycle through the sleep options again.
1
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
Press
RECEIVER
then press DIMMER repeatedly to
change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8
with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
impedance rating. Use
the front panel controls to do this.
With the receiver in standby, press
STANDBY/
ON
while holding down the
SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
SP 6 OHM
– Use this setting if your speakers are
rated at 6
.
SP 8 OHM
– Use this setting if your speakers are
rated at 8
or more.
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press
STATUS
to check the system settings.
These appear on both the OSD and the front panel
display.
2
The front panel display shows each of the following
settings for three seconds each:
2 When you’re finished, press
STATUS
again to
switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel
TONE
button,
press and hold
STANDBY/ON for about three
seconds.
The display shows
RESET?
.
3 Press the front panel
ENTER
button.
The display shows
RESET OK?
.
4 Press
SYSTEM SETUP
to confirm.
OK
appears in the display to indicate that the receiver
has been reset to the factory default settings.
Note that all settings will be saved, even if the
receiver is unplugged.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
Off
30 min 60 min
90 min
XM RADIO
ROOM 2HDMI2
CD-R/TAPE
ANALOG
AT T
MIDNIGHT/
LOUDNESS
VIDEO
SEL
DIMMER
SLEEP
SR+
DACCESS
DIALOG E
S.RETRIEVER
iPod
RECEIVER
TUNERHDMI1
SHIFT
STEREO
STATUS
SIGNAL SEL
THX
ADV.SURR
SBch
AUDI O
DISP
SUBTITLE
MULTI OPE
STANDARD
PHASE
S.DIRECT
MCACC
HDD
CH
CH
DVD
2 If the Pure Direct mode is switched on, some settings above will show
OFF
, even though they are on.
Input source Listening mode
Signal select Surround Back Processing
Sound Retriever Video Select
MCACC Position ROOM 2
STATUS
DOLBY DIGITAL 3/2.1
PCM 96+DOLBY PLII MS
Signal Select : AUTO
SBch Processing: OFF
Retriever : ON
Video Select : OFF
MCACC Position : M1
Room 2 : DVD
VSX-9110TXV_KU.book.fm 63 ページ 2006年4月4日 火曜日 午後5時15分