Pioneer PDK-1014 Stereo Receiver User Manual


 
Other Settings
11
68
En
Assigning the component video inputs
Default settings:
Component 1
OFF
Component 2
OFF
If you used component video cords to connect your video
equipment you must tell the receiver which device it is, or
else you may see the S-video or composite video input
instead of the component video signal.
1 Select ‘Component Input’ from the Input Assign
menu.
The illustration above shows the VSX-2014i OSD.
2 Select the number of the component video input
to which you’ve connected your video component.
Select between
DVD/LD
,
TV/SAT
,
DVR
,
VIDEO1
or
OFF
.
The numbers correspond with the numbers beside
the inputs on the back of the receiver.
3 Select the component that corresponds with the
one you connected to that input.
Use the
/
(cursor left/right)
buttons and
ENTER
to do this.
Make sure you have connected the audio from the
component to the corresponding inputs on the rear
of the receiver.
If you connect any source component to the receiver
using a component video input, you should also have
your TV connected to this receiver's component video
MONITOR
output.
4 When you're finished, press RETURN.
You will return to the Input Assign menu.
Assigning the i.LINK inputs
VSX-2014i model only
If you assign i.LINK-equipped components to an input
(for example
DVD/LD
), you will be able to select both
audio and video signals from i.LINK-equipped
components using the corresponding
MULTI CONTROL
button.
1 Select ‘i.LINK Input’ from the Input Assign menu.
2 Select an i.LINK-equipped component.
When a number of i.LINK-equipped components are
connected to your receiver, the i.LINK-equipped
component you are looking for might be listed on
additional display screens.
If no i.LINK-equipped components are connected,
you won’t be able to assign any inputs.
i.LINK
is displayed after unassigned device names
(e.g.
DV-868AVi [i.LINK]
).
If a connected devices cannot output (playback) a
source using the i.LINK connection,
[- - - -]
is
displayed after the input device name (e.g.
DV-
868AVi [- - - -]
). Non-compatible devices cannot be
assigned to inputs.
When the cables for an assigned input device
become loose or the power is cut to the device, an
asterisk (
) appears before the device name (e.g.
DV-868AVi [DVD/LD]
).
3 Select the component that you want to assign.
Use the
/
(cursor up/down)
buttons and
ENTER
.
When you assign an i.LINK-equipped video component,
select the input source to which you have connected the
video signal from the component.
If you assign an i.LINK input to a certain function (for
example
DVD/LD
) then any digital inputs previously
assigned to that function will automatically be set to
i.LINK
(not assigned).
The
TUNER
input cannot be assigned.
4 When you're finished, press RETURN.
You will return to the Input Assign menu.
5. Input Assign
[ a . Digital Input ]
[ b . Component Input ]
[ c . i. LINK Input ]
5b. Component Input
Component-1 [ DVD/LD ]
Component-2 [ OFF ]
5. Input Assign
[ a . Digital Input ]
[ b . Component Input ]
[ c . i. LINK Input ]
5c. i.LINK Input (1/1)
( End )
1 DV - 868AVi [ DVD/LD ]
2 DV - S858Ai [ i.LINK ]
( Top)
VSX_2014TX.book.fm Page 68 Wednesday, June 2, 2004 5:21 PM