Filter
Top Products
The System Setup menu
06
43
En
2 Select the setting you want to check.
• It is useful to do this while a source is playing so you
can compare the different settings.
3 Select the channels you want, pressing ENTER
when you’re finished checking each one.
4 When you're finished, press RETURN.
You will return to the Manual MCACC setup menu.
Manual speaker setup
This receiver allows you to make detailed settings to
optimize the surround sound performance. You only
need to make these settings once (unless you change the
placement of your current speaker system or add new
speakers).
These settings are designed to fine-tune your system, but
if you’re satisfied with the settings made in
Automatically
setting up for surround sound (MCACC)
on page 11, it
isn’t necessary to make all of these settings.
Caution
• The test tones used in the System Setup are output at
high volume (the volume increases to 0db
automatically).
1 Select ‘Manual SP Setup’ then press ENTER.
2 Select the setting you want to adjust.
If you are doing this for the first time, you may want to
adjust these settings in order:
•
Speaker Setting
– Specify the size and number of
speakers you’ve connected (page 44).
•
Crossover Network
– Specify which frequencies will
be sent to the subwoofer (see
Crossover Network
below).
•
Channel Level
– Adjust the overall balance of your
speaker system (page 45).
•
Speaker Distance
– Specify the distance of your
speakers from the listening position (page 46).
3 Make the adjustments necessary for each
setting, pressing RETURN to confirm after each
screen.
3g. EQ Data Check
Type [ ALL CH ADJUST ]
Ch [ Left EQ]
40Hz : 0.0dB
125Hz : 0.0dB
250Hz : 0.0dB
4kHz : 0.0dB
13kHz : 0.0dB
TRIM : 0.0dB
3g. EQ Data Check
Type [ ALL CH ADJUST ]
Ch
[ Left EQ]
40Hz : 0.0dB
125Hz : 0.0dB
250Hz : 0.0dB
4kHz : 0.0dB
13kHz : 0.0dB
TRIM : 0.0dB
3g. EQ Data Check
Type [ ALL CH ADJUST ]
Ch
[ Left EQ]
40Hz :
0.0dB 0.0dB
125Hz : 0.0dB
250Hz : 0.0dB
4kHz : 0.0dB
13kHz : 0.0dB
TRIM : 0.0dB
System Setup
[ 1 . Surr Back System ]
[ 2 . AUTO MCACC ]
[ 3 . MANUAL MCACC ]
[ 4 . Manual SP Setup ]
[ 5 . Input Assign ]
[ 6 . Other Setup ]
Enter : Select
Return : Exit
4. Manual SP Setup
[ a . Speaker Setting ]
[ b . Crossover Network ]
[ c . Channel Level ]
[ d . Speaker Distance ]
VSX_2014TX.book.fm Page 43 Wednesday, June 2, 2004 5:21 PM