Pioneer V2550E Home Theater System User Manual


 
65
INSTALLATION AND ASSEMBLY
6-screen assembly (work requires at least 3 persons)
1) First make a 4-screen assembly using screens 1, 2, 4 and 5.
(See the procedure for the 4-screen assembly)
2) Horizontally connect screen 6 to the side of screen 5 (Fig. 3-4-36).
Fix in 2 places (top and bottom)
Screws: Cross-recessed small screws (nominal diameter 4, length 25) (included as accessories)
Alignment
Up/down alignment: Align screens 5 and 6 such that their upper edges are at the
same height (Fig. 3-4-36).
Forward/backward alignment: Align so that the screen surfaces (wrench surfaces) are at the
same height.
3) Place screen 3 on top of screen 6 and connect it to screens 6 and 2 (Fig. 3-4-37).
Fix in 2 places (top and bottom of left edge)
Fix in 2 places (left and right of lower edge)
Screws: Cross-recessed small screws (nominal diameter 4, length 25) (included as accessories)
Alignment
Left/right alignment: Push screen 3 against the right edge of screen 2 (Fig. 3-4-37).
Forward/backward alignment: Place screen 3 on top of screen 6.
4) Mount on the cabinets
(as for RM-V2550S - see P50 [3])
5) Fix the screen frame
Fix with a screw in one place only - the center of the lower edge of the system (see Fig. 3-4-48 and
P53 [6])
Screw: Cross-recessed self-tapping screw (nominal diameter 4, length 12, cone point) (included
as accessory)
(Fig. 3-4-38)
(Fig. 3-4-37)
(Fig. 3-4-36)
Align so as to form a
straight line
Notes
* When carrying the 6-screen assembly, make sure that 2 people hold the screen, with one person holding
each edge as in Fig. 3-4-38, and that a third person supports the top of the assembly.
* Before mounting the screens on the cabinets, check that there is no dirt on the screens. If there is dirt on
the screens, wipe them clean with a soft cloth. In particular, you will not be able to clean the Fresnel surface
after mounting on the cabinets.
* For small pieces of dirt on the joints, do not use a dry cloth, but rather wipe clean with a cloth that you have
moistened with water and then wrung out well.
First Fix 2 + 3
Second Fix 3 + 6