Filter
Top Products
68
INSTALLATION AND ASSEMBLY
5) Vertically connect screens 3, 6 and 9 (Fig. 3-4-44).
You should connect in the order 9+6, 96+3.
Fix in a total of 4 places (left and right)
Screws: Cross-recessed small screws (nominal diameter 4, length 25) (included as accessories)
Alignment
Left/right alignment: Align so that the joints on the left sides of screens 3, 6 and 9
form a straight line (Fig. 3-4-44).
Forward/backward alignment: Align so that the screen surfaces (wrench surfaces) are at the
same height.
6) Mount the group consisting of the 3 vertically connected screens 3, 6 and 9 on a cabinet.
(as for RM-V2550S - see P50 [3])
Notes
* There should be a position-determining pin in each of screens 5 and 8 (which have already been
mounted on a cabinet).
Since these pins protrude about 6mm, when you mount the vertically connected group of screens 3 , 6
and 9, you should at first leave a gap of at least around 10mm between this group and the right-hand side
of the previously mounted group (screens 2, 5 and 8) (Fig. 3-4-43a).
You should then push the group of screens 3, 6 and 9 to the left until the vertical joints come together.
When doing this, you should make sure that the pins go into the holes in the left-hand sides of the frames
of screens 6 and 9 as in Fig. 3-4-43b.
You will then be able to line up the heights of the vertical joints on the two groups of screens.
You should not carry out the fixing work yet.
Cabinet
Screens
Align so as to form a straight line
Push together
Approx. 10mm
View from above
(Fig. 3-4-43a)
Engage pin in hole
Align so as to form a straight line
(Fig. 3-4-43b) (Fig. 3-4-44)