Pioneer V2550BU Home Theater System User Manual


 
60
INSTALLATION AND ASSEMBLY
3 1mm-screw screen (RM-V2550S2) assembly
(Note: ‘Left’ and ‘right’ in the text refer to the case that the screen is viewed from the front)
Step 1: Preparing the cabinets
Attach the screen frame fasteners as for the RM-V2550S (see P48 [9]).
Step 2: Opening the packaging
Remove the screens from their packaging (see P37).
Decide in advance where in the multi-screen assembly you will put each screen.
Take out the accessories affixed to the bottom of the packaging.
Notes
* Handling the screens
1) When carrying a screen, make sure that you hold it in the designated positions (Fig. 3-4-26). In particular,
do not hold the screen near the middle of the long side since if you do so there is a risk of it being
damaged.
2) Handle the joints with care.
When carrying out the work, avoid knocking the joints or touching them with your fingers, since if you do
so there is a risk of damage.
3) It is difficult to get the screens to stand up unsupported, so if you wish to leave one somewhere
temporarily, you should either stand it up against a wall (taking care that the joints do not come into
contact with the wall) or else lay it down with the screen surface facing upwards.
Carry the screen in both hands, holding it from the
points marked with circles . Do not hold it around
the middle of the edge of the frame.
(Fig. 3-4-26)