Filter
Top Products
HDMI Control
09
39
En
Setting the Auto Delay
This feature automatically corrects the audio-to-video
delay between components connected with an HDMI
cable. The audio delay time is set depending on the
operational status of the display connected with an
HDMI cable. The audio delay time is automatically
adjusted according to the video delay time.
1 Press SETUP.
2 Select ‘HDMI Setup’ then press ENTER.
3 Select ‘Auto Delay’, then press ENTER.
4 Select ‘A.Delay On’ or ‘A.Delay Off’ then
press ENTER to confirm.
Tip
• This feature is only available when the connected
display supports the automatic audio/video
synchronizing capability (‘lip-sync’) for HDMI or
HDMI Control. If you find the automatically set delay
time unsuitable, set
A.Delay
to
Off
and adjust the
sound delay settings manually (page 27).
Audio input settings from plasma televisions
(TV Input)
To listen to audio from a plasma television on this device,
you will need to connect an audio cable other than an
HDMI cable. From this menu, set the audio input to that
which you would like to connect. Press
TV
on the remote
control to switch this unit to the input source selected
here. This setting is changed to the selected input and
the audio from the plasma television is output from this
device.
Select from inputs
Digital 1
,
Digital 2
and
Analog
.
1 Press SETUP.
2 Select ‘System Setup’ then press ENTER.
3 Select ‘TV Input’, then press ENTER.
4 Adjust the setting then press ENTER to
confirm.
Important
• You must set this setting to activate the HDMI Control
function.
Before using synchronization
Once you have finished all connections and settings, you
must:
1 Put all components into standby mode.
2 Turn the power ON for all components, with the
power for the plasma television being turned on
last.
3 Choose the HDMI input to which the TV is
connected to this unit, and see if video output from
connected components displays properly on the
screen on not.
Synchronized amp mode
Synchronized amp mode begins once you carry out an
operation for the plasma television. For more
information, see the operating instructions of your
plasma television.
Synchronized amp mode operations
By connecting a component to this unit with an HDMI
cable you can use synchronized amp mode, which allows
you to synchronize the following operations:
• Displays on the plasma television when you mute or
adjust the volume of this unit.
• The input of this unit is automatically changed when
playback occurs on a connected component.
• Even if you change this unit’s input to a device that is
not connected by HDMI, the synchronized amp mode
remains in effect.
• By pressing
GENRE
when listening to a source from
an HDD/DVD recorder, the most appropriate
listening mode is automatically selected (page 26).
Canceling synchronized amp mode
If you cancel synchronized amp mode while connected
via HDMI to a plasma television or while you are watching
a TV programme, the power for this unit is turned off.
SETUP
ENTER
ENTER
ENTER
SETUP
ENTER
ENTER
ENTER
HTP-LX70_En.book 39ページ ２００７年９月２８日 金曜日 午前１０時５１分