1
En
S-RS3TB
S-RS7TB
Operating Instructions
Speaker System
WHAT’S IN THE BOX
BEFORE USE
Thank you for buying this Pioneer product.
Please read through these operating instructions before
using your speaker system to optimize performance.
• The nominal impedance of this speaker system is
8 Ω. Connect the speaker system to an amplifier with
a load impedance ranging from 4 Ω to 16 Ω (a model
with “4 Ω to 16 Ω” displayed on the speaker output
terminals).
In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
• When connecting or disconnecting cables, be sure
amplifier power is OFF.
• Do not use excessive amplifier volume if using a tone
control to emphasize high or low frequencies.
INSTALLATION PRECAUTIONS
• Do not install these units near a stove or other
heating appliance, or put them in a place exposed to
the sun. Such locations may cause the cabinet to
change color and the speaker system to break down.
• Do not use the speaker to output distorted sound for
long periods of time. This can result in a fire hazard.
• Do not connect this speaker to any amplifier other
than the one supplied with this system. Connection
to any other amplifier may result in a malfunction or
a fire.
FRONT / CENTER SPEAKERS
• Do not attach the front and center speakers to the
wall or ceiling. It may fall off and cause injury.
• This speaker system is magnetically shielded.
However, depending on the installation location,
color distortion may occur if the speaker system is
installed extremely close to the screen of a television
set.
If this happens, turn off the television, then turn it on
again after 15 min to 30 min. If the problem persists,
place the speaker system away from the television
set.
SURROUND SPEAKERS
• The surround speakers are not magnetically shielded
and so should not be placed near a TV or monitor, as
the interaction of magnetic materials can cause
distortion of the colors on your TV screen. Magnetic
storage media (such as floppy discs and tape or video
cassettes) should also not be kept close to these
speakers.
Front speakers x 2
Surround speakers x 2
Speaker cords x 5
Center speaker x 1
Non-skid pads x 20 (1 set)
Operating instructions
Screws x 8
Metal catches x 4
Center (2 m)
Front right/left (3 m)
Surround right/left (6 m)
S-RS7TBS-RS3TB
S-RS3TB_7TB_En_1st.fm 1 ページ 2008年6月26日 木曜日 午前9時27分