Filter
Top Products
8) AUDIO
Function: Pressing this button sets the audio switches.
Explanation: The current audio setting is displayed when the audio button is
pressed. Pressing this button repeatedly will change the audio status display
as shown below. The audio switch data is written into the Audio Control
Register.
A LaserDisc may be encoded with digital and analog audio or with only analog
audio. The on-screen display shows the outputs that are available depending on
the audio that is encoded on the disc that is playing. See Figure 3-E, Figure 3-F
and Figure 3-G below. NOTE: See Section 2.5.2 On Screen Display — Audio
Status on page 2-16. CDs are encoded with only digital audio. See page 3-11.
LaserDisc encoded with both analog and digital audio:
LaserDisc encoded only with analog audio:
Chapter Three • CLD-V2600 / 2400 Level I & III
3-10 TP 117 v. 2.0 • 12/93 CLD-V2600 / 2400 Level I & III User’s Manual
Figure 3-F
Digital Stereo
Digital 1/L
Digital 2/R
Digital Audio OFF
Analog Stereo
Analog 1/L
Analog 2/R
Analog Audio OFF
↓
↓
↓
↓
↓
↓
↓
Figure 3-E
Analog Stereo
Analog 1/L
Analog 2/R
Analog Audio OFF
↓
↓
↓