Pioneer CLD-V2600 CD Player User Manual


 
2.5.2 Area 2: Status Displays for Audio, Speed Set, Repeat Mode
& CLV Indicator
Audio commands are sent to the player by pressing the AUDIO button on the
remote control unit. Speed Set commands are sent by pressing the remote control
SPEED Buttons (Up or Down). Repeat Mode is set by pressing the REPEAT button.
The Audio or Speed or Repeat Mode status of the player is displayed in Area 2, the
upper right corner of the video monitor. See Figure 2-Q, on page 2-14.
Audio Status
Press the AUDIO button on the remote control unit to display the current audio
output status on the two top display lines (display lines 0 and 1) in the upper right
hand corner of the monitor. See Figure 2-U and Figure 2-V, below.
The first item, Digital or Analog, indicates whether audio output is to come from the
analog or digital channels of the videodisc. Then, the following options are available:
Stereo, 1/L, and 2/R and Audio Off. Digital, Analog and the options may be toggled
through by pressing the AUDIO button repeatedly. Digital Stereo is the default setting,
if digital audio is encoded on the disc.
NOTE: The Digital Sound indicator on the front of the CLD-V2400 player will be lit if
the disc being played is encoded with digital audio. On the CLD-V2600 player, the
words “Digital Sound” will be illuminated in the front panel display window.
Chapter Two • CLD-V2600 / 2400 Level I & III
2-16 TP 117 v. 2.0 12/93 CLD-V2600 / 2400 Level I & III User’s Manual
Figure 2-U
Figure 2-V
Digital
Stereo
Digital Analog
* Digital Stereo * Analog Stereo
* 1/L * 1/L
* 2/R * 2/R
* Audio Off *Audio Off