Filter
Top Products
CLD-V2600 / 2400 Level I & III • Chapter Two
CLD-V2600 / 2400 Level I & III User’s Manual TP 117 v. 2.0 • 12/93 2-7
Power Cord Connects to a wall outlet
(120V AC, 60 Hz). Note: For safety reasons,
this product uses a 3-line power cord and a
3-pronged power plug. Make sure to insert
the power plug into a wall outlet with a
ground terminal.
Interface Connector / RS-232C Port
D-SUB 15 pin. Used for serial interface connection to a
computer or a controller. See page 2-10 for details.
VIDEO OUTPUT Terminal (One RCA
Jack) This terminal is connected to the video
input jack of a color video monitor.
VHF Adapter Output Terminals These connect to
the RF modulator (supplied with the unit) that is used when
connecting to a normal TV. Note that TV audio will be
monophonic when using the RF modulator. The RF
modulator uses DC 5V power supplied from the player.
When the player is powered on, player audio & video signals
are output by the RF Modulator. When the player is turned
off, the modulator will pass an external antenna signal
through to the TV.
Power ON/OFF
Barcode Terminal for wired connection to
Pioneer Barcode Reader or Remote Control
Unit (CU-V113 or RU-V103).
Front Panel
Control
Buttons
Disc Tray Door
CLD-V2400 — Front Panel View
Figure 2-F
Figure 2-G
Remote Sensor for
receiving infrared signals
from the barcode reader or
remote control unit.
LaserDisc
LED Indicators
Digital Sound, Disc Set, Play Standby, Key Lock
CD CDV LD Player CLD-V2400
••••••••
•••••••
•
•
INTERFACE
CONNECTOR
CLD-V2400 — Rear Panel View
•
•
AUDIO OUT
1L 2R
OFF
ON
FUNCTION
SWITCHES
Video Audio
.
o
•
RF Adapter
Output
AUDIO OUTPUT Terminals (Two RCA Jacks) These
terminals output the audio of LaserDiscs and CDs. Connect them
to the LD or AUX input terminals of your stereo amplifier. Do NOT
connect these terminals to your amplifier PHONO input.
Function Switches
Function Switch 2 is on the left, and Switch 1 is on the right.
See Section 2.4, page 2-13 of this manual to set player functions.
Note: The VHF ADAPTER OUTPUT terminals are shared with the VIDEO OUT Terminal. Therefore, either a monitor or a TV can be
connected, but not both at the same time.