Filter
Top Products
Using Pioneer Barcode Readers
(cont.)
Scanning Barcodes with the UC-V108BC Autoscanning Reader
Place the Autoscanning reader sensor over the barcode. Line up the arrow on the scanner
with the left edge of the barcode. Press the blue READ button and the barcode is
automatically scanned. A “Beep” indicates the code has been successfully scanned. Before
transmitting the command, place a disc in the player and spin it up by pressing the PLAY
button on the reader, the PLAY button on the front of the player, or by scanning and
sending a “START” or “PLAY’ barcode command to the player.
Sending Barcode Commands to the Player with the UC-V108BC
Once a disc has been spun-up, barcode commands scanned with the UC-V108BC reader
can be transmitted to the player automatically in wired mode, or they can be sent in
infrared mode by pointing the infrared sensor on the front of the unit toward the remote
sensor on the player and pressing the SEND/REPEAT button.
When using the reader in infrared mode, make sure the control cable is disconnected from
both the player and the reader and that the batteries are fresh. The reader can transmit the
infrared signal approximately 23 feet with new batteries installed. The path of transmission
should be unobstructed and within a 30 degree angle of the remote sensor. The
Autoscanning reader holds the last barcode scanned in its memory; this barcode command
can be re-sent by pressing the SEND/REPEAT button again. A “Beep” indicates the code
has been successfully transmitted.
A control cable is packaged with the unit to provide a wired connection. The control cable
has mono mini plugs at both ends. The end that connects to the Autoscanning reader has a
locking connector and when inserted into the plug on the reader should be twisted to
provided a secure connection. The plug on the other end of the cable is simply connected to
the mini-jack on the front of the player. Make sure the player is turned off when connecting
or disconnecting the cable.
Built-in Remote Control Functions Available on the UC-V108BC
Remote control functions available at the press of a button include: Play, Pause, Step*
Forward and Reverse, Scan Forward and Reverse, Chapter / Track Skip** Forward and
Reverse, Audio Select and Display.
Pioneer Barcode Reader UC-V109BC
Overview of the UC-V109BC
Pioneer Barcode Reader UC-V109BC scans LaserBarcode
™
, LaserBarcode 2
™
and
Barcode CD
™
commands and sends them to control Pioneer’s barcode compatible
LaserDisc or combination LaserDisc/Compact Disc players. The UC-V109BC Barcode
Reader also has eight remote control function buttons built-in. It works with Pioneer
Industrial LaserDisc players LD-V8000, LD-V4400, CLD-V2600, CLD-V2400, LD-V2200,
the LC-V330 Auto Changer with LBA/15, the discontinued LD-V4200 with LBA/15, and
G-2 TP 117 v2.0 • 12/93 Appendix G Pioneer LaserBarcode Readers
* Step Fwd / Rev are used only with CAV discs; With the LD-V8000 player, however, they can be used with CAV and CLV discs.
* * The Skip Fwd / Rev function cannot be used with the LD-V8000.