Filter
Top Products
87
ENG/MASTER 98
88
Changing the Initial Settings
Correcting Distorted Sound
You can minimize distortion likely caused depending on the EQ curve settings.
1. Select “SENS” by moving the joystick.
“SENS” is highlighted in green.
2. Click the joystick.
Each click toggles SENS High/Low.
Note:
• Setting an EQ level high can cause distortion. If highs sound crippled or distorted, try switch-
ing to “Low”. Normally, leave the setting at “High” to ensure quality sound.
Setting the Time
This is the mode for setting the time on the product’s clock display.
1. Select “Adjust” by moving the joystick.
“Adjust” is highlighted in green.
2. Click the joystick.
The clock adjustment display appears on the screen.
3. Adjust “Hour” by moving the joystick
up/down.
4. Adjust “Minute” by moving the joystick
left/right.
As soon as you switch to “Minute”, the seconds start
counting from 00.
5. Click the joystick.
The clock adjustment display disappears.
Note:
• How to display the time indication is discussed under the heading of “Switching the Center
Screen and Time Display in the Center Room” on page 89.
CRB1585A/Eng/066-097 08-06-2000 14:51 Page 88