Filter
Top Products
5. Cancel the FAD/BAL Setting Menu by clicking the joystick.
Note:
• “F 00” is the proper setting when 2 speakers are in use.
Adjustments for Speaker
You need to make “with/without” (or yes/no) and “size” (bass reproducing capacity) selec-
tion/adjustments depending on the installed speakers. The size needs to be set to Large if the
speaker is capable of reproducing sounds of about 100 Hz or below. Otherwise select Small.
1. Select “SP Setting” by moving the joystick.
“SP Setting” is highlighted in green.
2. Click the joystick.
The Speaker Setting Menu appears.
The Front Left speaker is highlighted in green and in
the lower right-hand corner of the screen the current
settings of that speaker is shown.
68
ENG/MASTER 98
69
Adjusting Audio (Basic)
Continued overleaf.
Operation at the Speaker Setting Menu
• To select a speaker, move the joystick up/down and
left/right. You cannot move diagonally.
:Move the joystick left/right.
:Move the joystick up/down.
Test Tone: See “Adjusting the Speakers’ Output
Levels using a Test Tone” (p. 76).
Cross Over: See “Selecting a Crossover Frequency” (p. 77).
SW Phase: See “Correcting the Subwoofer’s Phase” (p. 77).
Audio Setting: Select this to go to the Audio Setting Menu.
Return: Completes operations at the Speaker Setting Menu, bringing you back to the
previous screen.
Center
Front Left
Rear Left
Sub Woofer
Front Right
Rear Right
Show the current settings
of the selected speaker
CRB1585A/Eng/066-097 08-06-2000 14:50 Page 69