Filter
Top Products
Troubleshooting
Common
Symptom Cause Action (See)
Power doesn’t turn on.
The unit doesn’ t operate.
Leads and connectors areincor-
rectly connected.
Confirm once more that all connections are
correct.
The fuse is blown. Rectifythe reason for thefuse blowing, then
replace the fuse.Be very sure to installthe
correct fuse with thesame rating.
Noise and other factors are causing
the built-in microprocessorto oper-
ate incorrectly.
Press RESET. (Page 13)
Playback is notpossible. The disc isdirty. Clean disc. (Page 121)
The loaded disc is a typethis unit
cannot play.
Check what typethe disc is.
Non compatible videosystem disc
is loaded.
Change to adisc compatible to your video
system.
No sounds areheard.
The volume levelwill not rise.
Cables are notconnected correctly. Connect thecables correctly.
The unit is performing still,slow mo-
tion or frame-by-frame playback.
There is nosound during still, slowmotion or
frame-by-frame playback.
There is nopicture. The parking brake cord is not con-
nected.
Connect a parkingbrake cord, and applythe
parking brake.
The parking brake isnot applied. Connect a parking brakecord, and apply the
parking brake.
The icon
is displayed, andop-
eration is notpossible.
The operation is prohibited for the
disc.
This operation isnot possible.
The operation is notcompatible
with the disc’s organization.
This operation isnot possible.
The picture stops(pauses) and
the unit cannotbe operated.
Reading of datahas become impos-
sible during playback.
After pressing g once,start playback once
more.
There is nosound.
Volume level islow.
The volume levelis low. Adjust the volume level.
The attenuator ison. Turn the attenuator off.
There is audioand video skip-
ping.
The unit is notfirmly secured. Secure the unitfirmly.
The picture isstretched, the as-
pect is incorrect.
The aspect settingis incorrect for
the display.
Select the appropriate setting for your display.
(Page 105)
When the ignitionswitch is
turned ON (orturned to ACC),
the motor sounds.
The unit is confirming whethera
disc is loadedor not.
This is anormal operation.
Nothing is displayed.
The touch panel keyscannot be
used.
The rear view camerais not con-
nected.
B.CAMERA is atincorrect setting.
Connect a rear viewcamera.
Press V.ADJ toreturn to the source display
and then select the correct settingfor
B.CAMERA. (Page 101)
Additional Information
En
117
Appendix
Additional Information