Pioneer AVH-P4050DVD Stereo Receiver User Manual


 
% Touch AM STEP on the initial menu to
select the AM tuning step.
Touching AM STEP will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (FULL) or subwoofer (S.W) con-
nection. If you switch the rear output setting
to S.W, you can connect a rear speaker lead
directly to a subwoofer without using an auxili-
ary amp.
Initially, the unit is set for rear full-range speak-
er connection (FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect other full range
speakers (REAR) or a subwoofer (S.W) to the
RCA rear output.
! When the multi-channel processor (e.g.,
DEQ-P7650) is connected to this unit, you
cannot operate this function.
1 Touch REAR SP on the initial menu.
2 Touch c or d next to REAR SP to switch
the rear output setting.
Touch c to select full-range speaker and FULL
appears in the display. Touch d to select sub-
woofer and S.W appears in the display.
# When no subwoofer is connected to the rear
output, select FULL (full-range speaker).
# When a subwoofer is connected to the rear
output, select S.W (subwoofer).
# When the rear output setting is S.W, you can-
not operate the following procedure.
3 Touch c or d next to PREOUT to switch
the subwoofer output or rear output.
Touching c or d will switch between S.W and
REAR and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
36).
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
% Touch TEL to select any of the muting,
attenuation or off.
Touch TEL until the desired setting appears in
the display.
! MUTE Muting
! ATT-20dB Attenuation (ATT-20dB has a
stronger effect than ATT-10dB)
! ATT-10dB Attenuation
! OFF Turn the sound muting/attenuation
off
Notes
! The sound is turned off, MUTE is displayed
and no audio adjustments are possible.
! The sound is attenuated, ATT is displayed and
no audio adjustments, except volume control,
are possible.
! Operation returns to normal when the phone
connection is ended.
Operating this unit
En
43
Section
03
Operating this unit