Filter
Top Products
CD/MP3 Operation
Basic playback controls
To play a disc
● Press 2; to start playback.
➜ The current track number and elapsed
playing time of the track are displayed during disc
playback.
To select a different track
● Press ¡1 2™ once or repeatedly until the
desired track number appears in the display.
To find a passage within a track
1 Press and hold down on ¡1 2™.
➜ The disc is played at high speed and low
volume.
2 When you recognise the passage you want,
release ¡1 2™.
➜ Normal playback continues.
To interrupt playback
● Press 2; during playback.
➜ The display freezes and the elapsed playing
time flashes when playback is interrupted.
➜ To resume, press 2; again.
To stop playback
● Press 9.
Notes: CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: TUNER or DOCK.
– you select standby
Playing an MP3,WMA disc
1 Load an MP3/WMA disc.
➜ The disc reading time may exceed 10
seconds due to the large number of songs
compiled into one disc.
➜ "XXX YY" is displayed. XXX is the current
track number and YY is the current album
number.
2 Press ALBUM 4 3 to select a desired album..
VOLUME
-
+
O
P
E
N
/
C
L
O
S
E
PROG/CLOCK
TUNING
CD
REP
MP3
ALL
PROG
POP
TRK
DBB
MICROSYSTEM
iR
MCM108D
Loading a disc
This CD player plays Audio Discs including CD-
Recordables, CD-Rewritables, MP3 CD and
WMA CD.
● CD-ROM, CD-I, CDV, VCD, DVD or computer
CDs, however, are not possible.
● DRM-protected WMA is not supported.
1 Select CD source.
2 Press OPEN/CLOSE3 on
the top of the system to open
the CD compartment.
➜ OPEN is displayed when
you open the CD compartment.
3 Insert a disc with the printe=d side facing up and
press down on OPEN/CLOSE3 to close the
CD door.
➜ READ is displayed as the CD player scans the
contents of a disc, and then the total number of
tracks and playing time (or the total number of
albums and tracks for MP3/WMA disc) are shown.
7
IMPORTANT:
The lens of the CD player should never be
touched.