Filter
Top Products
10
6 Change settings
This section helps you to change the settings of
your home theater.
Caution
Most of the settings are already conÀ gured •
with the best value for the home theater.
Unless you have a speciÀ c reason to change a
setting, it is best to leave it at the default value.
Access the setup menu
1 Press SETUP .
The following menu appears. »
Symbol Description
[General Setup]
[Audio Setup]
[Video Setup]
[Preference Setup]
2 Select a setup menu, then press OK .
See the following sections for information
about how to change the settings of your
home theater.
3 Press BACK to return to the previous
menu, or press
SETUP to exit.
Note
You cannot change a setting that is grayed out. •
Play from radio
The home theater can store up to 40 radio stations.
1 Check that the FM antenna is connected.
2 Press RADIO .
“ » AUTO INSTALL...PRESS PLAY ’ appears
on the display panel if you have not
installed any radio stations. Press
.
3 Press the following buttons to control play:
Button Action
/
Selects a preset radio station.
/
Searches for a radio station.
Fine tunes a radio frequency.
Press and hold to erase the
preset radio station.
Press to stop the installation of
radio stations.
PROGRAM Manual: Press once to access
program mode, and press again
to store the radio station.
Automatic: Press and hold for À ve
seconds to reinstall radio stations.
Note
AM and digital radio are not supported. •
If no stereo signal is detected, or if fewer than •
À ve stations are found, you are prompted to
install the radio stations again.
For the best reception, place the antenna away
•
from the TV or other sources of radiation.
Change tuning grid
In some countries, you can switch the FM tuning
grid between 50 kHz and 100 kHz. Changing
tuning grid erases all preset radio stations.
1 Press RADIO .
2 Press .
3 Press and hold until ‘GRID 9’ (50 kHz)
or ‘GRID 10’ (100 kHz) is displayed.
Play audio from TV or other
devices
Press AUDIO SOURCE repeatedly to select the
audio output of the connected device .
EN