22
English
3139 115 20912
Resume
This feature is also applicable to audio CD
(except for MP3-CD).
● In stop mode, press RESUME on the remote
control to start playback again from where you
have stopped.
Note:
– Resume information is lost if you have changed
the disc, opened the disc tray, change source or
disconnected the system from the power supply.
– Resume is not available when PBC mode is
switched on.
Slow
1 Press SLOW on the remote control to watch a
VCD at a slower speed. There are 3 types of
slow modes to select.
➜ The sound will be muted.
➜ On TV screen, “SLOW 1”, “SLOW 2” or
“SLOW 3” will be displayed.
2 To resume playback at normal speed, press
PLAYÉÅ.
Vocal
This feature allows you to fade out the original
vocal from a karaoke VCD. This feature is used
together with Echo mode. You can also use it to
select the different audio modes.
● Pressing VOCAL on the remote control
repeatedly allows you to select the following
modes.
➜ STEREO ™ STEREO VOCAL LEFT ™
STEREO VOCAL RIGHT ™ MONO LEFT ™
MONO RIGHT ™ STEREO …
STEREO – same effect as the original recorded
disc.
STEREO VOCAL LEFT/RIGHT – fade out the
original vocal for special recorded Karaoke disc
only (with the ECHO mode switched on).
MONO LEFT/RIGHT – select the language on a
bilingual VCD.
Ensure that Echo mode is switched on
when press VOCAL to fade out the original
vocal during STEREO VOCAL LEFT/RIGHT
mode.
CD/VCD/MP3-CD Operation
Key Control ( I È i )
This feature allows you to change the key tone
of your vocal range.
● Press
II
II
I on the remote control to decrease
vocal key level.
➜ "KEY -X" and appears on the display.
● Press
ii
ii
i on the remote control to increase vocal
key level.
➜ "KEY +X" appears on the display.
● Press
ÈÈ
ÈÈ
È on the remote control to restore vocal
key to original setting.
➜ "KEY FLAT" appears on the display.
Note:
–“X” denotes the key level.
Echo
This feature allows you to add echo while singing
or talking through a microphone.
● Press ECHO
--
--
-/
++
++
+ on the remote control to
decrease, increase or switch off the echo effect.
➜ "ECHO -X", "ECHO +X" or "ECHO OFF"
appears on the display.
Notes:
–“X” denotes the echo level.
– You are advised to switch off the echo effect
when not using the feature.
– If microphone is not inserted, “INSERT MIC”
will be displayed.
– Echo will switch off automatically when unplug
the microphone from the system.
pg 001-032/V720/21-Eng 6/5/01, 6:41 PM22