Filter
Top Products
20
English
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
IMPORTANT!
It is only possible to programme from
the current selected disc tray.
CD
REPEAT
DIM
DSC VAC MUTE MAX ON/OFF
SLEEP CLK/TIMER TIMER ON/OFF
PROGRAM SHUFFLE DISPLAY
CD1
CD4 CD5
CD2 CD3
TUNER AUX GAME
ALBUM
TITLE
VOL
GAME
GAME
SOUND
MIX-IT
M
P
3
1
2
4
7
53,
6
1 Load the desired discs into the disc trays (refer
to “Loading discs”).
2 Press CD or one of the CD 1~5 buttons to
select a disc.
3 Press PROGRAM (PROG) to start
programming.
➜ PROG starts flashing.
4 Press í or ë repeatedly to select the desired
track.
● For MP3 discs, press à / á (ALBUM 43)
and í / ë (TITLE - / +) to select the
desired album and title for programming.
5 Press PROGRAM (PROG) to store.
● Repeat steps 4–5 to select other tracks.
➜ If you attempt to programme more than 99
tracks, “PROGRAM FULL” is displayed.
6 To start programme play, press ÉÅ.
7 To stop playback or to end the programming,
press Ç once.
➜ PROG stays and the programming, mode
remains active.
Notes:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, “—:—” is displayed instead of the
total playing time.
– The system will exit the programming mode if
no button is pressed within 20 seconds.
Checking the programme
1 Stop playback and press í or ë repeatedly.
2 Press Ç to exit.
OR
Press ÉÅ to start playback from the current
programmed track
Clearing the programme
● Stop playback, then press Ç to clear the
program.
OR
Press the OPEN•CLOSE 0 button of the disc
tray.
➜ PROG disappears and “PROGRAM CLEARED”
is displayed.
Note:
– The programme will be erased if the system is
disconnected from the power supply or you switch
to other source mode.
Disc Operations