Philips FW-C780 Stereo System User Manual


 
9
English
3139 115 20592
Preparations
C Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to "R" and left
speaker to "L", coloured (marked) wire to "+"
and black (unmarked) wire to "-".
1
2
Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Rear Surround Speakers (for model
FW-C720 only)
Connect the speaker wires to the REAR
SURROUND terminals, right speaker to "R" and
left speaker to "L", coloured (marked) wire to
"+" and black (unmarked) wire to "-".
Notes:
For optimal sound performance, use the
supplied speakers.
Do not connect more than one speaker to any
one pair of
+
/
-
speaker terminals.
Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Optional Connections
The optional equipment and connecting cords
are not supplied. Refer to the operating
instructions of the connected equipment for
details.
Line Out Connection
Connect this output to any analogue audio
equipment for playback or recording (CD
recorder, tape recorder or amplifier for example).
Use a cinch cable to connect the LINE OUT
terminals to the analogue audio in terminals of
the equipment.
Connecting other equipment to your
system
Connect the audio left and right OUT terminals
of a TV, VCR, Laser Disc player, DVD player or
CD Recorder to the AUX/CDR IN terminals.
Notes:
Do not connect equipment to both the LINE
OUT and AUX/CDR IN terminals at the same time.
Otherwise, noise will be generated and malfunction
might occur.
If you are connecting equipment with a mono
output (a single audio out terminal), connect it to
the AUX/CDR IN left terminal. Alternatively, you
can use a “single to double” cinch cable (still be
mono sound).
Digital Out Connection
Connect this digital output when recording on
any audio equipment with digital input (CD
Recorder, Digital Audio Tape [DAT] deck, Digital
to Analogue Converter and Digital Signal
Processor, for example). Use a coaxial cable to
connect the DIGITAL OUT terminal to the
digital input terminal of the equipment.
Inserting batteries into the
Remote Control
Insert two batteries (Type R06 or AA) into the
remote control with the correct polarity as
indicated| by the + and - symbols inside the
battery compartment.
1
2
CAUTION!
Remove batteries if they are exhausted
or will not be used for a long time.
Do not use old and new or different
types of batteries in combination.
Batteries contain chemical substances, so
they should be disposed off properly.
pg 001-027/C720-C780/21-Eng 6/8/01, 8:44 AM9