Filter
Top Products
12
CQ-C7405W
Power on
Press [SOURCE] (PWR: POWER).
Power off
Hold down [SOURCE] (PWR: POWER) until
you hear a beep, then release it.
General
This chapter explains how to turn on or off the power, how to adjust the volume, etc.
You can remove the face
plate to prevent it from
being stolen.
Removing
1
Turn off the power (a page 12)
2
Press []
(Release).
(The face plate disen-
gages with a click
when it is removed.)
The face plate automatically closes after a lapse of 5
seconds while it is open.
The power is automatically turned off while the unit
is active.
3
Put the face
plate in the case.
Mounting
1
Slide the left side of the face plate in
place.
2
Press the right end of the face plate
until “click” is heard.
Cautions
¡It is recommended to remove or mount the face
plate when the plate is at the closed position.
Do not remove or mount the face plate when the
plate is in motion.
¡This face plate is not waterproof. Do not expose it to
water or excessive moisture.
¡Do not remove the face plate while driving your car.
¡Do not place the face plate on the dashboard or
nearby areas where the temperature rises to high
levels.
¡Do not touch the contacts on the face plate or on the
main unit, since this may result in poor electrical
contacts.
¡If dirt or other foreign substances get on the con-
tacts, wipe them off with clean and dry cloth.
¡To avoid damaging the face plate, do not push it
down or place objects on it while it is open.
OPENDISPBAND
CQ-C7405W
TILT/SET/APM
SQ
MENU
TUNE
TRACK
MUTE
SBC
-
SW
FOLDER/ P
-
SET/ DISC
LIST
SOURCE
PWR
/
V
O
L
P
U
S
H
S
E
L
/
S
R
S
W
O
W
D
・
M
OPENDISPBAND
CQ-C7405W
TILT/SET/APM/
Power On/off
(PWR: POWER)
Face Plate Removing/Mounting
(ANTI-THEFT SYSTEM)