Filter
Top Products
Danish Interpretation Systems User Manual
Manual 01 18 04438
14
Delegate setup
The “Delegate setup” menu comprises the
following entries:
• Max Speakers
• Max. Requests
• Operation Mode
• Voice Detection
• Auto Off Setup
Max Speakers
This menu point has two settings:
• Max. Total Speakers
• Max. Delegate Speakers
Values: {1, 2, 3, 4, 5, 6, 7, 8}
The number of ‘Total Speakers’ defines the
maximum number of conference units, which can
speak at the same time. This includes both delegate
and chairman units.
The number of ‘Delegate Speakers’ defines the
maximum number of Delegate conference units,
which are allowed to speak at the same time is
defined as “Max Speakers”.
Please observe that a Chairman Unit can always be
switched ON as long as the number set in ‘Max.
Total Speakers’ are not exceeded.
Max Requests
“Max Requests” defines how many delegate units
that can be inserted into the list of delegates
requesting to speak at the same time.
Values : {0, 1, …, 255}
Operation Mode
This menu point has two settings:
• Operation mode
• Interrupt
•
Operation mode
The “Operation Mode” determines the behaviour of
the microphone system.
Values: {Auto, Manual, FIFO, VOX}:
• Auto (or Automatic) mode allows for the
microphone units to be switched on
immediately upon pressing the microphone
ON/OFF button.
This is indicated by a red light in the
‘Speak’ lamp in the microphone unit.
Pressing the microphone ON/OFF button
again will turn the microphone off
A Chairman Unit is always in Auto or VOX
mode.
• Manual mode features a request list, where
‘Delegates’ are inserted in a queue upon
pressing the microphone ON/OFF button.
This is confirmed by a steady green light in
the ‘Request’ lamp in the delegate unit. It is
possible to cancel the request by pressing
the button again.
The microphone can only be switched on
from a PC running SW 6000 software or
from a control system like AMX or
Crestron. This will be indicated by red light
in the ‘Speak’ lamp in the microphone unit.
At this point the delegate can switch off the
microphone by pressing the ON/OFF
microphone button.
Although it is possible to switch to this
mode in a stand-alone-system, this mode is
only used with an attached PC running SW
6000 software or using with a control
system.
• FIFO is an automated mode. The
microphone unit functions in the same way
as in automatic mode as long as the number
of turned on delegate units is less or equal
to the selected maximum speakers.
When the max. number is reached, the next
delegate pressing the ON/OFF button will
be put in the top of the request queue. This
is indicated by the green ‘Request’ lamp
flashing slowly.