Filter
Top Products
Line 6 GearBox 3.1 – Basic Features Guide
*Note that when using TonePort KB37 with GearBox, the GuitarPort Player playback audio is
never routed to this S/PDIF output. This is necessary to comply with artist copyright requirements
that Line 6 follows for the GuitarPort Online Tracks and artist content.
Monitor In - If you want to hear the signal from a line level source mixed with all the other audio
coming from your computer, but do not want this audio recorded, then plug the source in here.
Note that this is a stereo jack, so you should use a stereo 1/4-inch TRS audio cable for this
connection.
Analog Outs - These Left and Right balanced jacks output all the audio from TonePort; the audio
from your audio software on the computer, and anything plugged into any TonePort input. So,
these are what you want to connect to your monitoring system when using TonePort as your
computer’s sound card. Use either 1/4-inch TS or TRS cables to connect directly to your powered
speakers, mixer or power amp setup. Note that you can also use the headphone jack on the front
of TonePort if you want to use headphones for monitoring.
TonePort DI Connections
Connect your
electric Guitar
or Bass
Guitar/Bass - To input your electric guitar or bass, plug it in here using a standard 1/4-inch TS
instrument cable. This input also features a Pad switch; engage this switch when using a
guitar/bass with high-output or active pickups, to avoid overdriving the input.
Page 34