Filter
Top Products
Line 6 GearBox 3.1 – Basic Features Guide
TonePort UX2 Connections
Connect your
stereo Headphones
Connect up to two
Microphones
Connect your electric Guitar or Bass
Microphone Inputs - You can receive input from one or two mics at the same time using these
ins. There is also a +48V Phantom Power switch that you should toggle to “on” if your mic
requires phantom power (most condenser type mics do, but check the documentation for your mic
if you are not sure). Connect each mic using an XLR cable. This inputs each microphone signal
independently into GearBox where you can choose your tone, and then route the processed signal
both to your audio software and out the TonePort outputs.
Guitar/Bass Inputs -To input your electric guitar or bass, plug it into one of these inputs. Either
of these routes the instrument’s signal into GearBox where you can choose your tone and route
the processed signal both to your audio software and out the TonePort outputs.
Norm – this input is for a standard instrument level output. Plug your guitar/bass into here using a
standard 1/4-inch TS instrument cable.
Pad - this input is designed for high output level basses and guitars, especially those with active
pickups. Plug your high output instrument into here using a standard 1/4-inch TS instrument
cable.
Headphone - If you want to listen to the audio from TonePort using stereo headphones, then plug
them into this 1/4-inch stereo jack. This Headphone jack outputs the same signal fed to the
Analog Outs on the rear panel of TonePort; the audio from your audio software on the computer,
as well as anything plugged into any TonePort input.
Page 30