Line 6 headphones powered monitors Headphones User Manual


 
Line 6 GearBox 3.1 – Basic Features Guide
Causes of excess noise or unwanted distortion and clipping
Noise and distortion? That's what electric guitar is all about, right!? But if you're hearing the bad
kind of noise or distortion from GearBox, there are several possible sources and solutions,
including the hardware output knob, the onscreen Monitor Volume knob and Out To Hardware
knob, Track playback clipping, soundcard noise, guitar noise, and speaker or audio system noise.
Let's run through each of these, and how it might be a part of your problem:
Output knob set too high – It's possible that your speakers, headphones or other audio
system can't handle the maximum output level from the TonePort or GuitarPort hardware or
PODxt that you are using. Try turning the knob on the hardware down and see if this
eliminates the distortion.
Different sources of Clipping – "Clipping" is audio distortion that happens when you have
some thing(s) turned up higher than a system is designed for, and the loudest parts of your
signal get clipped off as a result. Check your system's clipping indicators.
The GearBox Monitor Volume and Out To Hardware controls at the top of the window
have a little clip indicator light next to each. These are green when receiving a proper
level signal, and red if clipping. Back off the knob level if you see red here.
The GearBox amp panel also shows the word CLIP that lights up red to show when the
amp is clipping. The Track Level Slider within the Player will light up red when
clipping.
When PODxt is used, the word CLIP is shown on the PODxt's own screen.
If you see clipping displayed with either setup while you're playing back the Track and
playing guitar, but the clipping stops when you stop playing guitar and leave the Track
still playing, it probably means that the combination of the Track volume and guitar
volume are too much, even though neither one may clip on its own. In this case,
TonePort and GuitarPort hardware users should turn down the Out to Hardware Volume
and PODxt hardware users should turn down PODxt's OUTPUT knob. Or you can pull
back on the Track Level slider and the Amp Model's Volume knob a bit to get things out
of the clipping range.
Guitar Noise – It's easy to find out if your guitar or guitar cable is the source of your noise
problem. Just disconnect your guitar cable from your Line 6 hardware and see if the noise
goes away. If it does, try using a different guitar cable to see if the cable is the problem. If
changing the cable doesn't take care of it, you may just have a guitar with noisy pickups, or
your guitar may be picking up electrical noise from your computer's display or other sources.
You can generally reduce these noises with the GearBox Gate and Hum Reducer features.
Speaker or other Audio System Noise when using TonePort or GuitarPort hardware
It's also possible that the noise is occurring AFTER TonePort/GuitarPort, in your speakers,
headphones, or other system that you are connecting your device to for listening. If you're
using headphones, try another pair that you own or can borrow from a friend to see if the
headphones are the problem. If you're listening via multimedia speakers or other equipment,
try listening with headphones instead to see whether the noise is coming from
TonePort/GuitarPort or your speakers or audio system. You may have the volume turned too
high on the speakers or audio system, causing distortion there. Also, try unplugging the cable
Page 147