Line 6 headphones powered monitors Headphones User Manual


 
Line 6 GearBox 3.1 – Basic Features Guide
Download Accelerators are incompatible with GearBox/GuitarPort Online, and must be disabled
to successfully use GuitarPort Online. If you have frequent problems with incomplete downloads,
there is probably an issue with your Internet connection or the way it is setup, and you may need
to contact your Internet Service Provider for assistance. If you are using a dial-up modem
connection over regular phone lines and you have Call Waiting, be sure you have Call Waiting
turned off when using your Internet Connection so that the Call Waiting signal doesn't interrupt
your download. On some phone systems, you can dial *70 before a call to disable Call Waiting
for that one call.
Return to the Troubleshooting List
Light is off on GuitarPort or TonePort hardware
If the light on your GuitarPort or TonePort UX1 hardware does not light up, or if your TonePort
UX2 front panel meters do not light up, it means that the is not receiving power from the USB
connection. See
USB Errors.
Return to the Troubleshooting List
Multiple computers: using GearBox and GuitarPort Online on more than
one computer
You can use GearBox and the GuitarPort Online features with more than one computer if you
like. You will, of course, need to install the GearBox software on each computer. Once you've
done that, just connect your Line 6 hardware to the computer you'd like to use, start the GearBox
program and you'll be able to use both the standard features of GearBox and GuitarPort Online.
You won't be able to access any GearBox features without your Line 6 hardware connected.
Return to the Troubleshooting List
TonePort/GuitarPort hardware does not power up
The light on top of the GuitarPort and TonePort UX1 hardware comes on to show that it is
receiving power, and should be green when the driver is correctly initialized and ready to go.
TonePort UX2’s front VU meters will light up when the unit receives power. These units’ lights
should come on whenever connected via USB to your computer or hub. If it does not, see the
discussion of
USB Errors..
Return to the Troubleshooting List
Page 144