Filter
Top Products
_________________________________________________________________
STABI REFERENCE T U R N T A B L E 10 KUZMA
VI. GENERAL MAINTAINANCE
1. Dust with a soft cloth and any oil stains can be removed with detergent or alcohol.
2. Cleaning pulleys and belt:
This should be done occasionally (3 to 6 months) according to regularity of use.
a. remove platter to gain access to belt and pulleys. Remove belt. Switch on motors,
clean surfaces of pulleys and subplatter with cotton bud moistened with alcohol.
By hand rotate subplatter and clean it.
b. moisten cloth with alcohol and pull belt throught cloth to clean (ensure that
hands
are clean and grease free.
3. Cleaning of mat:
a. remove platter from turntable
b. squeeze alcohol onto mat until whole surface is wet.
c. with a toothbrush brush out from centre until alcohol evaporates.
4. Check oil in bearing:
The level of oil is not so critical due the use of metal versus non metal sliding
materials. However, the level of oil should be just under the height of ruby ball
and cca 2 mm height in the middle of lower bath.