Kenwood KVS-300 Speaker User Manual


 
Introduction
Your Kenwood KVS speakers were
designed to meet the demands of
today’s high-quality music recordings
and film soundtracks.
Your new speakers:
Deliver wide dynamic range and
powerful bass response
Feature quality-built acoustically-
optimized enclosures
Are magnetically-shielded for use
in audio/video systems
Were designed, engineered, and
assembled in the USA.
Installing the speakers isn’t difficult,
but please read and follow all of the
instructions in this manual to get
maximum performance from your
new speakers. If you’re also
connecting other equipment, such
as a receiver, power amplifier, or
pre-amplifier, use this manual in
combination with the materials that
came with those components.
Unpacking
Unpack your new speakers carefully
and examine them for shipping
damage. If they are damaged or fail
to operate, notify your dealer imme-
diately. If your speakers were
shipped to you directly, notify the
shipping company without delay.
Only the person or company who
originally received the unit can file a
claim against the carrier for shipping
damage. Keep the original carton
and packing materials in case you
need to transport or ship your
speakers.
About speaker wire
We ask you to buy the wire sepa-
rately, since we don’t know how
much wire you will need. We
suggest that you buy wire that is at
least 18-gauge or thicker.
Remember, the smaller the number,
the thicker the wire, so 18-gauge
wire is thicker than 20-gauge wire.
Before you run out to buy speaker
wire, read the section on ‘Placing
the speakers’ on page 3. You’ll need
to know where your speakers will
go before you buy the speaker wire.
For your records
Record the serial number (found on
the back of the unit) on the
warranty card, and in the space
below. If you need to call your
dealer for information or service,
you’ll need the model and serial
numbers. And be sure to save your
original receipt.
Model
Serial Number
Setting up your
Kenwood
KVS Speakers
KVS-