Filter
Top Products
Catch
Lock
Accessory2
Removal tool
English
— 34 —— 34 —
■ Removing the hard rubber frame
2 When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1 Engage the catch pins on the removal tool and remove the two
locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
Screw (M4X8)
(commercially
available)
■ Removing the Unit
4 Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5 Pull the unit all the way out
with your hands, being
careful not to drop it.
1 Refer to the section <Removing the hard rubber frame> and then
remove the hard rubber frame.
2 Remove the screw (M4 × 8) on the back panel.
3 Insert the two removal tools deeply into the slots on each side,
as shown.
Installation
KDC-X569_U.S r2 02.10.31 10:09 AM Page 34