Filter
Top Products
DP-5090/4090 (En)
18
The following procedure allows to record a CD within the
specified tape length so that no music is interrupted in the
middle at the ends of sides A and B.
Editing
Preparation
Press the numeric keys as shown below.
30-minute tape : 000)
46-minute tape : 00006
÷Recording within 99 minutes can be specified in minutes (2 digits).
÷If you commit a mistake in time entry, press the P.MODE key and
restart the procedure from the beginning.
÷By pressing the TIME DISPLAY key the set time-length intervals will
change in this order:
÷The interval length can be adjusted with the skip keys 4 and ¢ in
units of one minute (to a maximum of 99 minutes).
1
Light the “EDIT” indicator.
2
Enter the recording time of the tape.
÷Load a disc in the CD player.
÷Check that the unit is in the normal play
TRACK mode.
!
: Keys and control used in the operations described on this page.
REMOTE CONTROL UNIT
RC-P0505
COMPACT DISC PLAYER DP-5090
REMOTE CONTROL UNIT
RC-P0505
DETIC4-6
EDIT
DETIC?-?
Blinks.
TIME
DISPLAY
EDIT
REMOTE CONTROL UNIT
RC-P0505
REMOTE CONTROL UNIT
RC-P0505
12
3
45
6
78
9
0 +10
2 Set the entry.
1. While you can edit with a different time setting to that of the tape you are using, part of the tape may be left with nothing recorded on it, or
the last track on side A or side B may be cut short.
2. The EDIT function may not operate properly for discs having only one track or having tracks of long duration such as classical music.
Notes
Notes
Do this operation in the stop mode.
Go to step 2 within 8 seconds.
If more than 8 seconds have elapsed,
press the key again.
1 Select the time.
When using the numeric keys:
When using the TIME DISPLAY key:
"
46=54=60=74=90=??
"
=
The CD contents are edited as follows.
(1) The tape recording time input is divided by two, and tracks that can
be accommodated in file A (which refers to tracks on tape side A) are
selected in order of their track Nos.
(2) In a few seconds, the time left on tape side A is displayed, then file
B (tracks on tape side B) is edited in the same manner.
Editing in the FILE A
DETIA01
The selected track numbers are displayed in sequence.
DETIA 1-2:3
Remaining time display.
➡