Filter
Top Products
+
12V
WARNING: The rectangular shape of the
Subwoofer provides increased resistance to
tipping. To avoid vehicle damage or personal
injury that may occur should the enclosure become
detached, please ensure that the enclosure is
securely mounted to a surface with adequate strength
and rigidity to support it under stress conditions such
as road vibration and sudden stops.
NOTICE: There are no removable or serviceable parts
on the speaker. Tampering with the speaker or any of
it's components will damage the speaker and void the
warranty.
CARE AND CLEANING: Fingerprints and smudges
can be removed from the acrylic by buffing lightly with
a lint-free cloth. Light scratches can be buffed out by
using an acrylic/plexi polish or fine rubbing compound;
however, avoid getting any compound on the cabinet
carpeting. The enclosure is the same material used
for premium quality home audio speakers, but
covered with carpet instead of veneer. Dirt on the
carpet can be cleaned with common carpet cleaners
and a brush.
SL212
Audiovox Electronics Corporation
150 Marcus Blvd • Hauppauge, New York 11788 • ©2007 Audiovox Electronics Corporation
MADE IN CHINA
NOMINAL IMPEDANCE: 4 OHM
Chassis
Ground
12 volt switched
+ DC source
+
+
-
12V DC Input for Jensen Lighting
NOTE: Must use 12 volt switched output ONLY.
Head Unit
Connecting 12V DC Power for
Lighting
The lighting features of all Jensen
products require a 12 volt power source to
operate. The polarity (+ and -) indicators
for each set of inputs also appear on the
terminal cup.
Do not connect an amplifier or any audio
source to Jensen lighting inputs. Inputs
are designed for a switched 12-Volt DC
power source only. Do not connect your
Jensen product directly to your battery, as
it will cause your battery to discharge.
Be sure to maintain polarity. and be sure
to connect to a constant switched 12 volt
source. Connect the switched positive (+)
12 volt wire to the Positive (+) lighting
input terminal and connect the negative
(- ) lighting input terminal to a good
chassis ground or negative (- ) ground
Wiring Your Bass Enclosure
Connect the positive (+) wire from amplifier output to
the positive terminal (red) on enclosure.
Connect the negative (-) wire from the amplifier output
to the negative terminal (black) on enclosure.
Jensen SL210/212 Slot-Loaded Subs Quick Start Guide
Need help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.