Jasco 99003 Headphones User Manual


 
7
phone on the headset. Phones that do not support ring indication
will automatically accept the call.
When using the GE99003 headphones with a music source and a
phone at the same time, the headphones should be paired with
the phone before pairing with the audio device.
Pairing Mode
The pairing mode allows your 99003 headset to pair (connect) with
Bluetooth enabled transmitters.
1. With the headphones OFF, press and hold the power button
for a total of 6 seconds to turn the headphones ON and enter
the Discovery/Pairing Mode.
2. The two LEDs will fl ash in the following sequence:
Blue – Red – Blue, pause, repeat.
3. First time pairing may take up to two minutes. If pairing fails,
the 99003 headset will go into the standby mode. Turn the
headset OFF and try again.
Pairing the headphones to a Bluetooth enabled phone
for the fi rst time
Use the phone’s menu system to pair it with your phone if you
want to be able to use your 99003 stereo headphones as a
hands-free headset. ”Pairing” creates a link between a Bluetooth-
enabled phone and the GE 99003 stereo headphones. It allows
the phone to remember the headset’s unique Bluetooth ID. You
may add it to your phone’s “Paired Device” list. The headset needs
to be paired only ONE time with the phone before use.
1. Power ON your GE 99003 headphones and activate the
“Discovery/Pairing Mode” as directed above.
2. Make sure your Bluetooth enabled phone is turned on and
within 6 feet of the headphones.