Filter
Top Products
Limited Lifetime Warranty
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI
Technologies), warrants this product to be free from defects in workmanship and
materials, under normal use and conditions, for the lifetime of the product from
the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return
it to the store where it was originally purchased. Should this fail to resolve the
matter and service still be required by reason of any defect or malfunction during
the warranty period, SDI Technologies will repair or, at its discretion, replace this
product without charge (except for a $2.00 charge for handling, packing, return
UPS/postage, and insurance). This decision is subject to verification of the defect
or malfunction upon delivery of this product to the Factory Service Center listed
below. The product must include proof of purchase, including date of purchase.
The fee for service without proof of purchase is $4.00.
Before returning this product for service, please first replace the batteries (if
applicable) with fresh ones, as exhausted or defective batteries are the most
common cause of problems encountered.
If service is still required:
1. Remove the batteries (if applicable) and pack the unit in a well padded, heavy
corrugated box.
2. Enclose a photocopy of your sales receipt, credit card statement, or other
proof of the date of purchase, if within the warranty period.
3. Enclose a check or money order payable to the order of SDI Technologies,
for the sum of $2.00 ($4.00 without proof of purchase).
4. Send the unit prepaid and insured, to the Factory Service Center listed below.
Consumer Repair Department
SDI Technologies Inc.
1330 Goodyear Drive
El Paso, TX 79936-6420
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which
it was designed. It does not cover (i) products which have been damaged by
negligence or willful actions, misuse or accident, or which have been modified
or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units
damaged by excessive heat; (iii) damage to digital media players, CD’s or tape
cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service
Center and its return to the owner.
This warranty is valid only in the United States of America and does not extend
to owners of the product other than to the original purchaser. In no event will SDI
Technologies or any of its affiliates, contractors, resellers, their officers, directors,
shareholders, members or agents be liable to you or any third party for any
consequential or incidental damages, any lost profits, actual, exemplary or punitive
damages. (Some states do not allow limitations on implied warranties or exclusion
of consequential damages, so these restrictions may not apply to you.) This
warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
Your acknowledgement and agreement to fully and completely abide by the above
mentioned disclaimer of warranty is contractually binding to you upon your transfer
of currency (money order, cashier's check, or credit card) for purchase of your
SDI Technologies product.
© 2012 SDI Technologies, Inc. All rights reserved
Questions? Visit www.ihomeaudio.com or call 1-800-288-2792 Toll Free.
iB22-120612-A
Printed in China
Model: iB22
Noise Isolation Earbuds
with Interchangeable
Ear Cushions
Using Your iHome Headphones
The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear
and the “R” earpiece in your right ear for proper fit and best sound. If the
earpieces are inserted incorrectly they will not fit properly in your ears and the
sound quality will not be satisfactory.
Connect the headphone plug to the headphone jack of your music player. Be
sure that the plug is fully inserted into the jack. If the plug is not fully inserted
you may only hear sound from one earpiece.
NOTE: Your headphones are supplied with three different size silicon tips
(S-M-L) for maximum comfort and to seal out unwanted noise. The “M”
(medium) size tips were installed at our factory. If you find that the installed
tips are too small or too large for your ears, you may remove them and
replace them with the larger or smaller size accessory tips. To replace the
tips simply pull them off the earpieces. To install different size tips, push them
on to the earpieces and make sure they are fully seated on each earpiece so
that they do not come off when you remove the earpiece from your ear. If
one of the tips remains in your ear when you remove the headphones,
remove the tip carefully and avoid pushing it further into your ear canal. Seek
medical assistance if one of the tips becomes lodged in your ear and you are
unable to remove it.
IMPORTANT! Listening at high volume for long periods of time can result in
long-term hearing damage. For your safety, do not use headphones if they
would prevent you from hearing warning sounds, such as while driving a car
or motorcycle, riding a bike, etc.
NOTE: In extremely cold or dry air conditions you may notice a slight ‘tingling’
feeling in your ears when using in-ear headphones. This is the result of the
build-up of static electricity in your body. This is normal and not an indication
of any problem with your headphones.
The hang tag at this top of the package also functions as a convenient cord
management device. Pass the headphone plug through the opening in the
hang tag as shown and then wind the headphone cord around the hang tag.
This will keep your headphone cord tangle free and always ready to use.
Cord Managment