Filter
Top Products
19
5
MEMORY OPERATION
DD
To indicate the channel name [
The channel name indication can be set independently for
eace memory channel.
qSelect the desired memory channel.
➥ Push [MR•SKIP] to select memory mode
, then rotate
[DIAL] to select the desired memory channel.
•“!” and memory channel number appear.
wPush [SET•LOCK] to enter set mode.
ePush [SET•LOCK] or [S.MW•MW] several times to select
“Anm” item.
rRotate [DIAL] to turn the memory name indication ON.
tPush [TS•MODE] to exit set mode
.
NOTE: When no memory name is programmed, the stored
frequency is displayed.
■ Copying memory contents
This function transfers a memory channel’s contents to VFO
(or another memory channel). This is useful when searching
for signals near a memory channel frequency and for recalling
the subaudible tone frequency, etc.
D Memory➪VFO
qSelect the desired memory channel to be transferred.
➥ Push [MR•SKIP] to select memory mode
, then rotate
[DIAL] to select the desired memory channel.
•“!” and memory channel number appear.
wPush and hold [S.MW•MW] for 3 sec. to transfer the se-
lected memory channel contents to VFO mode
.
• VFO mode is selected automatically.
D Memory➪memory
qSelect the desired memory channel to be transferred.
➥ Push [MR•SKIP] to select memory mode
, then rotate
[DIAL] to select the desired memory channel.
•“!” and memory channel number appear.
w Push [S.MW•MW] momentarily.
•“!” and memory channel number blink.
e Rotate [DIAL] to select the target memory channel.
• Scan edge channels, 0A/0B to 49A/49B can also be selected.
r Push and hold [S.MW•MW] for 1 sec. to transfer the se-
lected memory channel contents to the target memory
channel.
• The targeted memory channel and transferred contents are dis-
played.