Harman-Kardon SB15/230 Home Theater System User Manual


 
4
4 5
Surround
Mode
Button
Surround
Mode
Indicator
Power
Button
Power
Indicator
Volume
Up/Down
Buttons
Source
Selector
Button
Source
Indicator
Power Button: When the soundbar is in the Standby mode (the Power Indicator is
amber), press this button to turn the SB 15/230 system On. (The Power Indicator
turns blue.) NOTE: When the soundbar is in the Standby mode, it will automatically
turn On whenever it detects an audio signal at the Source 1 (analog) inputs.
When the SB 15/230 system is On:
Momentarily press the Power button to mute the SB 15/230 system. (The Power
Indicator flashes blue.)
Hold down the Power button for three seconds to put the soundbar in the Standby
mode. (The Power Indicator turns amber.) NOTE: The subwoofer will remain on for
approximately 15 minutes after the audio signal ceases, then will automatically
go into the Standby mode.
Surround Mode Button: This button turns the SB 15/230 system’s 3D Surround
processing On and Off. The Surround Mode Indicator turns blue when 3D Surround
is active, and turns white when 3D Surround is not active (normal stereo sound). See
Soundbar Surround Mode Button, on page 8, for more information.
Volume Up/Down Buttons: Press the ( – ) button to reduce the volume; press the
( + ) button to increase the volume.
Source Selector Button: This button switches between the sources connected
to the Source 1 (analog) and Source 2 (digital) inputs. When Source 1 is active, the
Source Indicator turns white; when Source 2 is active, the Source Indicator turns
blue.
Wireless Code Switch: Selects between four different channels for the wireless
subwoofer signal.
IMPORTANT: Be sure to set the subwoofer’s Wireless Code switch to the same channel
that you set the soundbar’s Wireless Code switch. See Wireless Code Switches, on
page 9, for more information.
EQ Switch: This switch adjusts the soundbar’s bass for either wall or table mounting.
If you’re mounting the soundbar on a wall with the included wall-mount brackets, set
this switch to the Wall position for the most natural-sounding bass performance. If
you are placing the soundbar on a table, set the EQ switch to the Table position for the
most natural-sounding bass performance.
Trim Switch: This switch adjusts the soundbar’s input sensitivity so it will work
with TVs that have different audio signal output levels. See Soundbar Trim Switch, on
page 9, for more information.
Source 1 Connection (analog): Use the included stereo audio cable to connect the
stereo analog outputs of your TV, DVD player or cable/satellite tuner here.
Source 2 Connection (digital): If your TV, DVD player or cable/satellite tuner has a
coaxial digital output, you can connect it here.
NOTE: If you connect your TV or another component to the soundbar’s Source 1
connection, you can connect a different component to the Source 2 connection.
Power Connection: Connect the included DC power supply here. See Power
Connections, on page 7, for more information.
IMPORTANT: Do not connect the power supply’s AC cord to an AC outlet until you have
made and verified all connections.
Power Switch: Set this switch to the On position (press the switch’s white dot) to
activate the soundbar. In normal operation, this switch will be left in the On position.
See Turning the Soundbar On and Off, on page 8, for more information.
Soundbar Top-Panel Controls Soundbar Rear-Panel Controls
and Connections
EQ
Switch
Trim
Switch
Source 2
Connection
Power
Switch
Power
Connection
Source 1
Connection
Wireless Code
Switch