Harman-Kardon SB15/230 Home Theater System User Manual


 
10
10 11
You can program the soundbar so it will respond to your TV remote’s Power, Mute,
Volume Up, Volume Down and Source commands. This lets you control your whole
home theater system with a single remote. Before beginning to program the
soundbar, have your TV remote handy. We recommend sitting down in front of the
soundbar. The steps will time-out, so read through the entire procedure before you
begin.
To program the power command:
With the soundbar turned on, hold down the soundbar’s Power and Source 1.
Selector (SRC) buttons together until all the soundbar button indicators flash. This
enters the learning mode.
Hold down
both buttons until
all indicators flash
Momentarily press the soundbar’s Power button. It will turn amber.2.
Momentarily
press
Aim the TV remote at the front of the soundbar from about 300mm-900mm 3.
(about 12-36 inches) away.
TV
Remote
300mm-900mm
12"-36"
Hold down the TV remote's Power button for one second, then release it. Do this 4.
a total of four (4) times. When the soundbar has learned the power command,
its Power Indicator will turn blue, and the Surround Mode and Source Selector
Indicators will flash blue.
If the Power Indicator flashes amber, the procedure failed. Repeat Steps 1 – 4.
To program the source, volume + and volume – commands:
Follow Steps 1–4 as above, but in Steps 2 and 4, substitute the soundbar and TV
remote’s Source Selector and Volume Up/Down buttons for the Power buttons.
To program the mute command:
Follow Steps 1-4 as above, but in Step 2, hold down the soundbar's Power button for
2-3 seconds. In step 4, substitute the TV remote's Mute button for its Power button.
To erase all remote programming:
Hold down the soundbar's Surround Mode and Volume Up buttons at the same time
for 2-3 seconds.
Programming the Soundbar to Respond to Your TV Remote