Filter
Top Products
10 SPEAKER CONNECTIONS
Speaker Connections
Dolby Pro Logic (Non-Digital) –
Line Level
Use this installation method for Dolby Pro Logic
applications (not Dolby Digital, DTS
®
or other
digital processing), where the receiver/processor
is equipped with a subwoofer output, or a
volume-controlled preamp (line-) level output:
Use RCA-type patch cords to connect the line-
level subwoofer output on your receiver or to
amplifier either the left or right line-level input
on the subwoofer.
Use both the left and right inputs on the sub-
woofer if your receiver or processor has both left
and right line-level outputs. In that case, you will
need to supply a second interconnect cable.
If your receiver is equipped with line-level out-
puts but does not have a separate subwoofer
output, use a Y-adapter (not supplied) to bridge
the receiver’s preamp output to the main amp
input for that channel, and connect the long end
of the adapter to the corresponding line-level
input on the SUB-TS11.
IMPORTANT: Do not use the Sub Input
4
on
the subwoofer with Dolby Pro Logic processors.
If your receiver/processor has a built-in low-
pass-crossover filter for the subwoofer output,
you may use the Sub Input
4
to bypass the
subwoofer’s internal crossover.
Connect each speaker to the corresponding
speaker terminals on your receiver or amplifier.
Make sure that you have configured your
surround sound processor for “Subwoofer On.”
The front left, front right, center and surround
speakers should all be set to “Small.”
When all connections have been made, plug the
AC power cord on the subwoofer into an AC
outlet.
Receiver
SUB/LFE
Out
Front
Left
Surround
Left
Front
Right
Surround
Right
SUB-TS11
Subwoofer
Center
Line-Level
R
L
– +
– +
– +
– +
– +
Surround
Right
Front
Right
Surround
Left
Front
Left
Center