Filter
Top Products
DPR 1005 DIGITAL PATH RECEIVER
3 Introduction
4 Important Safety Information
4 Unpacking
5 Front-Panel Controls
8 Rear-Panel Connections
11 Main Remote Control Functions
15 Zone II Remote Control Functions
16 Installation and Connections
19 System Configuration
19 Speaker Placement
19 System Setup
20 Input Setup
22 Audio Setup
22 Surround Setup
24 Speaker Setup
26 Delay Settings
27 Output Level Adjustment
27 Using EzSet
28 Manual Output Level Adjustment
30 Operation
30 Basic Operation
30 Source Selection
30 6/8-Channel Direct Input
30 Volume and Tone Control
31 Surround Mode Selection
31 Digital Audio Playback
32 Surround Mode Chart
35 Tuner Operation
35 Tape Recording
35 Front-Panel Connections
36 Output Level Trim Adjustment
37 Advanced Features
37 Front-Panel Display Fade
37 Display Brightness
37 Turn-On Volume Level
37 Semi-OSD Settings
38 Full-OSD Time-Out Adjustment
39 Multiroom Operation
39 Multiroom Setup
39 Surround Amplifier Channel Assignment
40 Multiroom Operation
41 Configuring the Remote
41 Programming Remote Codes
41 Preprogrammed Code Entry
42 Automatic Code Entry
42 Learning Commands
43 Changing Devices
44 Macro Programming
46 Punch-Through Configuration
47 EzSet Configuration
48 Renaming
49 Resetting the Remote
51 Troubleshooting Guide
51 Processor Reset
52 Technical Specifications
See trademark acknowledgements on page 52.
2 TABLE OF CONTENTS
Typographical Conventions
In order to help you use this manual with the remote control, front-panel controls and rear-panel connections,
certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front-panel button, or rear-panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on-screen or on the front-panel
information display
EXAMPLE – (Synchro type) indicates a message that is displayed on the remote control’s LCD screen
1 – (number in a square) indicates a specific front-panel control
A – (letter in a square) indicates a front-panel control that is behind the drop-down door
¡ – (number in a circle) indicates a rear-panel connection
a – (number in an oval) indicates a button or indicator on the remote
å
– (letter in an oval) indicates a button on the Zone II remote