Harman-Kardon CDR 20 CD Player User Manual


 
9 REAR-PANEL CONNECTIONS
Rear-Panel Connections
¡
™
£
¢
∞
§
⁄
ª
AC 100-240V 50-60Hz 26W
CDR
IN
¶
•
‚
OPTICAL
CDP
OUT
¡ Play Deck (CDP) Analog Output
Record Deck (CDR) Analog Output
£ Record Deck (CDR) Analog Input
¢ Play Deck (CDP) Coaxial-Digital Output
Record Deck (CDR) Coaxial-Digital Output
§ Record Deck (CDR) Coaxial-Digital Input
Record Deck (CDR) Optical-Digital Input
Play Deck (CDP) Optical-Digital Output
ª Remote IR Input
Remote IR Output
AC Power Cord
¡ Play Deck (CDP) Analog Output: These
jacks carry the analog audio output signal from
the Play Deck 3. Connect them to the CD
input jacks on a receiver, preamp or processor.
Record Deck (CDR) Analog Output:
These jacks carry the output signal from the
Record Deck %. Connect them to the Tape
Play/In input jacks on a receiver, preamp or
processor.
£ Record Deck (CDR) Analog Input: These
jacks accept the analog signals that are used
for CD recordings. Connect them to the Tape
Rec/Play outputs on a receiver, preamp or
processor.
¢ Play Deck (CDP) Coaxial-Digital
Output: This jack carries the digital-audio out-
put signal from the Play Deck 3. Connect it
to a coaxial-digital input on a receiver, proces-
sor or digital decoder.
Record Deck (CDR) Coaxial-Digital
Output: This jack carries the digital audio out-
put signal from the Record Deck %. Connect
it to a coaxial digital input on a receiver,
processor or digital decoder.
§ Record Deck (CDR) Coaxial-Digital
Input: This jack accepts the digital-audio input
signal from a compatible digital audio product
and should be connected directly to a digital
player or to a coaxial-digital output on a CD or
DVD player or an A/V receiver or processor.
IMPORTANT NOTE: The coaxial digital inputs
should only be connected to digital input or
output jacks. Even though they use the same
RCA type connector as standard analog audio
connections, DO NOT connect them to conven-
tional analog input or output jacks.
Record Deck (CDR) Optical-Digital
Input: This jack accepts the digital-audio input
signal from a compatible digital audio product,
and should be connected to the optical-digital
output on a CD or DVD player or an A/V
receiver or processor.
Play Deck (CDP) Optical-Digital
Output: This jack carries the optical digital
output signal from the Play Deck 3. Connect
it to an optical digital input on a receiver,
processor or digital recorder.This will typically
be connected to the “CD” input.
ª Remote IR Input: Connect the output of a
remote infrared sensor or the remote control
output of another compatible Harman Kardon
product to this jack.This will enable the remote
control to operate even when the front-panel
Remote Sensor Û is blocked. This jack may
also be used with compatible IR remote control
based automation systems.
Remote IR Output: Connect this jack
to the IR input jack of another compatible
Harman Kardon remote controlled product to
have the built-in remote sensor Û on the
CDR 20 provide IR signals to other compatible
products.
AC Power Cord: Connect this plug to an
AC outlet. If the outlet is switch controlled,
make certain that it is in the ON position.